Philips 954 manual Centrex Operation, Setup Checklist, Setting Up a Fourth Line for Each Station

Page 30

CENTREX OPERATION

Setup Checklist

Before expanding your system or installing for Centrex, review the installation checklist. If you have Centrex, contact your local telephone company for further information about Centrex service.

•The phone number for Line 1 must be the same on all phones in order for the Intercom and Paging features to work.

•Determine the number of phones that will be on the system.

•Identify the phone that will be the attendant phone.

•Identify the private line for the attendant phone. The attendant phone must have its own private line. This line is not shared with any other phone.

•Follow the regular installation instructions in this manual.

•Enable the attendant phone.

•Store the Centrex pickup codes and the seven-digit phone numbers into memory locations. See TELEPHONE MEMORY in this manual.

Setting Up a Fourth Line for Each Station

1Press G*#.

2Enter the line number (05–08) you want as your fourth line. For example, if stations 16, 19, and 20 share Line 5, those stations would enter 05.

3Press and release H. You’ll hear a confirmation ring.

Repeat Steps 1–3 for each station on the system that will have a private line.

Enabling/Disabling Attendant Station

This feature lets you have an attendant phone on the system. An attendant phone can pick up other Centrex lines through Centrex switching. Identify which station you want as the attendant. The attendant phone should also have a private line.

1Make sure the phone is not in use.

2Press G*#*.

3Press 1to enable

— OR —

Press 0to disable.

4Press M. You’ll hear a confirmation ring.

27

Lucent 0954 book.L1

27

5/7/98, 10:36 AM

Page 29 Page 31
Image 30
Page 29 Page 31
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneConnect the power adapter Connect the handset cordCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line
Top Page Image Contents