Philips 954 manual Paging All Phones, Answering an Allpage, Making an Intercom Conference Call

Page 26

INTERCOM OPERATION

Paging All Phones

1Press and release aor p.

2Press and release *.

3Speak toward the telephone.

4Press and release Kto disconnect.

Answering an ALLPAGE

1Press aor p.

2Use the already activated speakerphone, or lift the handset.

3To end, press and release Kor hang up.

Making an Intercom Conference Call

1Make or answer a call.

2Press and release Iand enter the station number.

3After the third party answers, press and release C.

4To end an intercom conference call, hang up.

NOTE: You cannot put an intercom conference call on hold.

Room Monitor

You can activate the speaker of another phone to monitor sounds in that room.

1Press and release p.

2Enter the station number of the telephone to be monitored.

3Press and release Mif you don’t want sounds on your end to be heard.

4To end monitoring, press and release K.

Checking Your Station Number

1Press and release I.

2Use the dial pad to enter a station number (11 to 22).

3Press Kto hang up.

4Repeat Steps 1–3 until the intercom light goes off. The last number entered is your station number.

NOTE: If the intercom light stays on even after you enter numbers 11 through 22, your phone does not have a station number. See “Assign Intercom Number” in the TELEPHONE FEATURE SETUP section for assigning intercom station numbers.

23

Lucent 0954 book.L1

23

5/7/98, 10:36 AM

Image 26
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line