Philips 954 manual Auto Redial, Switch Between Lines, Disabling Hold Reminder

Page 18

OPERATION

Redial

The last number dialed on this phone is stored in redial memory until you dial another number. To dial the same number again, lift the handset or press K, listen for the dial tone, then press R.

Auto Redial

Select a line and press A. The screen displays BUSYDIAL as long as the number you’re calling is busy. The phone redials the number you just called, and will continue up to 10 times or until the other line rings or you cancel Auto Redial.

When you hear the line ringing, lift the handset or press Kto complete the call; if you don’t, the phone disconnects the call after 15 seconds. To cancel Auto Redial, press A, or lift the handset, or press K.

Hold

Press and release H. The light of the line on hold flashes, and a double beep sounds every 30 seconds to remind you the call is on hold. You can replace the handset in the cradle without disconnecting the call. The speakerphone is automatically turned off.

To release Hold, press and release the LINE button of the call on hold.

NOTE: You cannot put an intercom call on hold.

Disabling Hold Reminder

This phone comes programmed to remind you every 30 seconds when you have a call on hold. You can turn this feature off following the directions below.

1Press G, *, #, *.

2Press and release 4to turn off the alert beep

— OR —

Press and release 5to turn on the alert beep.

3Press and release M. You will hear a confirmation ring.

Switch Between Lines

1Press and release Hto keep a call on the first line.

2Press and release the LINE button of another line to make or answer another call.

NOTE: If you switch lines without pressing Hfirst, you will drop the call.

15

Lucent 0954 book.L1

15

5/7/98, 10:35 AM

Image 18
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Install 3 AAA batteries InstallationTable/Desk Installation Connect the telephone line cords to the telephoneConnect the power adapter Connect the handset cordCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Assign Intercom Number Telephone Feature SetupSet Dial Mode Set the ClockSet Up for a Private Line Change Battery DisplaySet for Two or Three Phone Lines Operation Making a Call Call PrivacyLine-In-Use Lights Ringer Volume VolumeHandset/Speakerphone Volume Control Turning Ringer OffAuto Redial Switch Between LinesRedial HoldTemporary Tone Dialing MuteFlash Conference CallsTransferring an Announced Call Do Not DisturbTransfer a Call Transferring an Unannounced CallTimer Telephone Memory Storing Numbers in Memory Storing a Temporary Tone Signal in a Memory NumberDirectory Card Storing a Pause in a Memory NumberIntercom Operation Answering an Intercom Call or Basic Intercom OperationsMaking an Intercom Call or Ending an Intercom Call orMaking an Intercom Conference Call Paging All PhonesAnswering an Allpage Room MonitorCase of Difficulty Operation During a Power Failure Intercom Paging Signal Not ReceivedTone Signals Do Not Activate a Remote Device Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Centrex Operation Setup ChecklistSetting Up a Fourth Line for Each Station Enabling/Disabling Attendant StationSetting Ring Delay Duration Answering a Delayed RingAttendant Operation Picking Up Another Station’s Line