Philips 954 manual Handset/Speakerphone Volume Control, Ringer Volume, Turning Ringer Off

Page 17

OPERATION

Volume

Handset/Speakerphone Volume Control

When you are on a call, press +to increase handset or speakerphone volume. Press -to decrease volume.

Ringer Volume

You can adjust the ringer volume while the phone is ringing. While the line is ringing, press +or -to reach the desired level. If more than one line is ringing at the same time, both will be adjusted.

This phone has four ringer volume levels. Each time you adjust the ringer, you will hear a sample indicating the volume level. To adjust ringer volume when the line is not ringing, follow the steps below.

1Press and release C.

2Choose the line for ringer adjustment. Press and release 1for Line 1

— OR —

Press and release 1for Line 2

— OR —

Press and release 3for Line 3

— OR —

Press and release 4for Line 4.

3Press +to increase volume

— OR —

Press -to decrease volume.

Turning Ringer Off

1Press and release C.

2Choose the line for ringer adjustment. Press and release 1for Line 1

— OR —

Press and release 2for Line 2

— OR —

Press and release 3for Line 3

— OR —

Press and release 4for Line 4.

3Press -until you no longer hear a tone.

14

Lucent 0954 book.L1

14

5/7/98, 10:35 AM

Image 17
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Table/Desk Installation InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneCheck for dial tone Connect the power adapterConnect the handset cord Reverse the handset tab Wall InstallationConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Set Dial Mode Telephone Feature SetupAssign Intercom Number Set the ClockSet for Two or Three Phone Lines Set Up for a Private LineChange Battery Display Operation Line-In-Use Lights Making a CallCall Privacy Handset/Speakerphone Volume Control VolumeRinger Volume Turning Ringer OffRedial Switch Between LinesAuto Redial HoldFlash MuteTemporary Tone Dialing Conference CallsTransfer a Call Do Not DisturbTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Directory Card Storing a Temporary Tone Signal in a Memory NumberStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Making an Intercom Call or Basic Intercom OperationsAnswering an Intercom Call or Ending an Intercom Call orAnswering an Allpage Paging All PhonesMaking an Intercom Conference Call Room MonitorCase of Difficulty Tone Signals Do Not Activate a Remote Device Intercom Paging Signal Not ReceivedOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setting Up a Fourth Line for Each Station Setup ChecklistCentrex Operation Enabling/Disabling Attendant StationAttendant Operation Setting Ring Delay DurationAnswering a Delayed Ring Picking Up Another Station’s Line