Philips 954 manual Making a Call, Call Privacy, Line-In-Use Lights

Page 16

OPERATION

NOTE: When you make a call, the phone selects the first available line. When you answer a call, the phone automatically selects the ringing line. If you have a private line, the phone automatically selects that line.

Making a Call

Handset

To make a call, lift the handset. You can dial your call manually or use the memory dialing feature.

To answer a call, lift the handset. Replace the handset to end the call.

To override automatic line selection, press and release a LINE button (this activates the speakerphone), then lift the handset.

Speakerphone

To make a call, press and release K. The SPEAKER light goes on. Wait for a dial tone, then dial the call manually or by using memory dialing.

To answer a call, press K. Press Kagain to end the call.

To switch from handset to speakerphone, press K, then replace

the handset.

To switch from speakerphone to handset, lift the handset.

To override automatic line selection, press and release a LINE button (this activates the speakerphone).

Call Privacy

To ensure call privacy, the phone allows only one set at a time to use a line.

Canceling Call Privacy

During the call, press the line button for the call. You’ll hear a short ringing tone. Others can now join the call.

Restoring Call Privacy

Press the line button again during the call. You’ll hear a double-ring. The other phones will be dropped from the call.

NOTE: Call privacy is automatically restored when you end the call.

Line-In-Use Lights

Whenever a line is in use, the light flashes slowly on the phone using that line. On the other phones, the light stays on steadily to indicate someone else is using the line.

13

Lucent 0954 book.L1

13

5/7/98, 10:35 AM

Page 15 Page 17
Image 16
Page 15 Page 17
Contents BUYMEBUYME.COM User’s Manual for Four-Line Intercom/ Speakerphone Philips Consumer Communications L.P. All rights reserved Contents Lucent 0954 book.L1 98, 1034 AM Before YOU Begin Installation Table/Desk InstallationInstall 3 AAA batteries Connect the telephone line cords to the telephoneConnect the handset cord Connect the power adapterCheck for dial tone Wall Installation Reverse the handset tabConnect the power adapter to the telephone Mount the phone on the wall Standard Electrical Outlet Convenience Port Telephone Feature Setup Set Dial ModeAssign Intercom Number Set the ClockChange Battery Display Set Up for a Private LineSet for Two or Three Phone Lines Operation Call Privacy Making a CallLine-In-Use Lights Volume Handset/Speakerphone Volume ControlRinger Volume Turning Ringer OffSwitch Between Lines RedialAuto Redial HoldMute FlashTemporary Tone Dialing Conference CallsDo Not Disturb Transfer a CallTransferring an Announced Call Transferring an Unannounced CallTimer Telephone Memory Storing a Temporary Tone Signal in a Memory Number Directory CardStoring Numbers in Memory Storing a Pause in a Memory NumberIntercom Operation Basic Intercom Operations Making an Intercom Call orAnswering an Intercom Call or Ending an Intercom Call orPaging All Phones Answering an AllpageMaking an Intercom Conference Call Room MonitorCase of Difficulty Intercom Paging Signal Not Received Tone Signals Do Not Activate a Remote DeviceOperation During a Power Failure Cannot Use DND, TIMER, Allpage or SETExpanding the 954 System Setup Checklist Setting Up a Fourth Line for Each StationCentrex Operation Enabling/Disabling Attendant StationAnswering a Delayed Ring Setting Ring Delay DurationAttendant Operation Picking Up Another Station’s Line
Top Page Image Contents