TG8011_8021BX(e).book Page 29 Monday, September 29, 2008 1:07 PM
Programming
Registering a handset to a base unit
The supplied handset and base unit are
1Handset:
K(middle soft key) i Ni
M
2{V}/{^}: “Registration” i M2 times
3{V}/{^}: Select a base unit number. i M
L This number is used by the handset as a reference only.
4Base unit:
Proceed with the operation for your model.
■
■
Press and hold {x} for about 5 seconds, until the registration tone sounds.
L If all registered handsets start ringing, press the same button to stop. Then repeat this step.
L The next step must be completed within 90 seconds.
5Handset:
Wait until “Enter Base PIN” is displayed. i Enter the base unit PIN (default: “0000”). i M L If you forget your PIN, contact
your nearest Panasonic service centre.
L When the handset has been registered successfully, w stops flashing.
Note:
L When you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Selecting a base unit
When “Auto” is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1K(middle soft key) i Ni
M
2{V}/{^}: “Select Base” i M
3{V}/{^}: Select the desired base unit number, or “Auto”. i M L The handset starts searching for
the base unit.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This allows the handset to end its wireless connection with the system.
1K(middle soft key) i <i
M
2{3}{3}{5}
3{V}/{^}: “Deregistration” i
M
L The numbers of all handsets registered to the base unit are displayed.
4Select the handset(s) you want to cancel by pressing the desired handset number. i M
L The selected handset number(s) flashes.
L To cancel a selected handset number, press the number again. The number stops flashing.
29