Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then insert the batteries into the handset again.
General use
Problem
The handset does not turn on even after installing charged batteries.
The unit does not work.
I cannot hear a dial tone.
The base unit beeps.
Cause/solution
RPlace the handset on the base unit or charger to turn on the handset.
RMake sure the batteries are installed correctly (page 10).
RFully charge the batteries (page 10).
RCheck the connections (page 10).
RUnplug the base unit’s AC adaptor to reset the unit. Reconnect the adaptor and try again.
RThe handset has not been registered to the base unit. Register the handset (page 35).
RThe base unit’s AC adaptor or telephone line cord is not connected. Check the connections.
RDisconnect the base unit from the telephone line and connect the line to a known working telephone. If the working telephone operates properly, contact our service personnel to have the unit repaired. If the working telephone does not operate properly, contact your service provider/
telephone company.
RNew messages have been recorded. Listen to the new messages (page 41).
Programmable settings
Problem
The display is in a language I cannot read.
I cannot register a handset to a base unit.
Cause/solution
RChange the display language (page 14).
RThe maximum number of handsets (6) is already registered to the base unit. Cancel unused handset registrations from the base unit (page 35).
Battery recharge
Problem
The handset beeps and/or flashes.
Cause/solution
RBattery charge is low. Fully charge the batteries (page 10).
For assistance, please visit http://www.panasonic.com/help | 53 |
TG684x7x(en)_1127_ver021.pdf 53
2012/11/27 18:16:49