Browser Operation
wwConnecting the Center Module via a PC
1Launch the PC’s Web browser.
2Input the Center Module IP address into the address bar of the Web browser.
Example) http://Center Module IP address
This unit has the following default settings as the time of shipment:
IP address: 192.168.0.50
Port number: 80
Protocol: http
Important
ppIf the HTTP port number has changed from “80”, input [http://Center Module IP address: port number] into the [Address bar].
Example) If the port number is set to 8080: http://192.168.0.50:8080
3When a connection has been established between the Center Module and the PC, an authentication
The following are the default setting username and password:
Username: admin
Password: 12345
ppIf authentication is successful, the operation screen will appear.
Note
ppThe IP address of the Center Module can be checked on the Center Module screen. For details, refer to the Operating Instructions <Installation Guide>.
Important
ppBe sure to change the username and password to ensure that the system is secure. For details, see “Configuring server settings” (p. 13).
wwSetup Instructions
This section describes basic operation procedures to set this unit with browser operations.
1
2
1Input the necessary information into the settings.
2Click the [Set] button.
Important
ppThe settings will not be reflected unless the [Set]
button is clicked.
ppDo not click the button repeatedly. Doing so may result in the settings being set incorrectly.
9