Browser Operation
[NTP server address]
If “Manual” is selected for [NTP server address (Manual
/Auto)], enter the NTP server IP address or host name manually.
Number of characters: 1 to 128
Types of characters: alphanumeric, characters
Default setting: None (blank)
Important
ppWhen entering the host name into the “NTP server address”, the DNS setting must be configured on the [Network] tab of the [Installation] button on the Setup menu panel.
[NTP port]
Input the NTP server port number.
Settable port numbers: 1 to 65535
Default setting: 123
Important
ppThe following port numbers cannot be used. (Excluding the port number set in the default settings.) 20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Time adjustment interval time]
Select the interval for retrieving the time from the NTP server (1 hour units, from 1 to 24 hours).
Default setting: 1h
[Time zone]
Select the time zone corresponding to the region in which this unit is being used.
Default setting:
SMTP
Configure the settings of the email server for sending emails from the Center Module.
[Default] button
This button is used to restore the SMTP settings to the default settings.
[SMTP server address]
Input the IP address or host name of the SMTP server for sending email.
Number of characters: 1 to 128
Types of characters: alphanumeric, characters
Default setting: None (blank)
[SMTP server port]
Input the port number for sending email.
Settable port numbers: 1 to 65535
Default setting: 25
Important
ppThe following port numbers cannot be used. (Excluding the port number set in the default settings.) 20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Authentication]
ppType
Select one of the following authentication methods for sending email.
None: | No authentication |
POP before SMTP: | |
| Authenticate the POP servers for |
| receiving email before sending email. |
SMTP: | Authenticate the SMTP server. |
Default setting: None
Note
ppIf unsure of which authentication type to use for sending email, inquire with the system administrator.
ppUser name
Input the username for accessing the server. Number of characters: 0 to 32
Types of characters: | alphanumeric, characters |
|
Default setting: None (blank)
ppUser password
Input the password for accessing the server.
Number of characters: | 0 to 32 |
Types of characters: | alphanumeric, characters |
|
Default setting: None (blank)
[POP3 server address]
If [POP before SMTP] is selected for [Authentication Type], input the POP3 server IP address or host name manually. Number of characters: 1 to 128
Types of characters: alphanumeric, characters
Default setting: None (blank)
14