Windster 100 manual One Rack Unit

Page 18

1 U (1.75 inches)

Figure 14. One Rack Unit

For more information about requirements for installing components in a rack, see the

Dell Rack Advisor software available on the Dell World Wide Web site at:

http://support.dell.com.

WARNING: If you are installing more than one computer, install the slide assemblies so that the first computer is installed in the lowest available position in the rack.

To install the slide assemblies in the rack, perform the following steps:

1.Place the front of the template on the vertical rails at the front of the rack where you want to install the system.

Ensure that the printing on the template identifies the side facing outwards as the template front.

Position the bottom of the template in line with the desired bottom position of the computer chassis.

2.Mark the rack’s front vertical rails with a felt-tipped marker or place masking tape where the system’s upper and lower edges will be located (see Figure 15). Make a mark or place tape on the vertical rails next to the template’s V-shaped notches.

18 Dell PowerApp 100 Appliances Rack Installation Guide

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Two-Post Center-Mount Rack Kit Installation Rack Kit Contents Recommended Tools and SuppliesMarking the Rack Attaching the Brackets Two-Post Open-Frame Relay Rack 1-U Hole SpacingTwo-Post Flush-Mount Rack Kit Installation Installing the System in the RackRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Inner Rails on the System Chassis Installing the Bracket in the RackInstalling the System in the Rack Securing the Inner Rails to the System ChassisSecuring the Computer System in the Rack Four-Post Rack Kit Installation Four-Post Rack Kit Contents Before You BeginInstalling the Rack Kit Recommended Tools and SuppliesRemoving the Doors From the 42-U Rack Opening the 42-U Rack Door Removing the Doors From the 24-U Rack Removing the 42-U Rack DoorsUnlocking the 24-U Rack Door Installing the Slide Assemblies in the Rack Removing the 24-U Rack DoorsOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Cable-Management Arm Installing the Computer in the RackInstalling the Cable-Management Arm Replacing the Rack Doors Replacing the Rack Doors on a 42-U RackReplacing the Rack Doors on a 24-U Rack
Top Page Image Contents