Windster 100 manual Installing the Cable-Management Arm

Page 23

pin

captive

fastener

Figure 19. Installing the Cable-Management Arm

2.Align the free end of the cable-management arm (the end with the pin and cap- tive thumbscrew) to the back end of the right (or left) side inner rail (as viewed from the back) of the computer.

3.Secure the cable-management arm to the inner rail with the captive thumbscrew (see Figure 19).

4.Attach the input/output (I/O) cables to their respective expansion cards on the back of the PowerApp system.

5.Connect the remaining cables to the computer.

For details, see your system’s Troubleshooting Guide and the User’s Guide.

6.Secure the cables to the cable-management arm:

a.After connecting the cables to the computer, unscrew the thumbscrews that secure the front of the server to the front vertical rail.

b.Slide the system forward to the fully extended position.

c.Route the cables along the cable-management arm, allowing some additional cable slack at the hinge positions, and secure the cables to the cable-management arm with the Velcro straps attached to the cable-management arm.

support.dell.com

Dell PowerApp 100 Appliances Rack Installation Guide

23

Image 23
Contents Two-Post Center-Mount Rack Kit Installation Marking the Rack Rack Kit ContentsRecommended Tools and Supplies Two-Post Open-Frame Relay Rack 1-U Hole Spacing Attaching the BracketsInstalling the System in the Rack Two-Post Flush-Mount Rack Kit InstallationRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Bracket in the Rack Installing the Inner Rails on the System ChassisSecuring the Inner Rails to the System Chassis Installing the System in the RackSecuring the Computer System in the Rack Four-Post Rack Kit Installation Before You Begin Four-Post Rack Kit ContentsRemoving the Doors From the 42-U Rack Installing the Rack KitRecommended Tools and Supplies Opening the 42-U Rack Door Removing the 42-U Rack Doors Removing the Doors From the 24-U RackUnlocking the 24-U Rack Door Removing the 24-U Rack Doors Installing the Slide Assemblies in the RackOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Computer in the Rack Installing the Cable-Management ArmInstalling the Cable-Management Arm Replacing the Rack Doors on a 24-U Rack Replacing the Rack DoorsReplacing the Rack Doors on a 42-U Rack