Windster 100 manual Installing the Slide Assemblies

Page 20

10-32 x 0.5-inch

pan-head Phillips

screw (2 per slide

assembly)

mounting-bracket

flange

slide assemblies (2)

front of rack

Figure 16. Installing the Slide Assemblies

Installing the Inner Rails on the System Chassis

To install the inner rails to the sides of the system, perform the following steps.

CAUTION: The computer may weigh up to 15.8 kilograms (35 pounds) when fully loaded. To prevent personal injury, do not attempt to move the com- puter by yourself.

1.Place the computer on its side (see Figure 17) on a piece of foam or cardboard (to prevent damage to the computer) while you install the inner rails to the sides of the system.

20 Dell PowerApp 100 Appliances Rack Installation Guide

Image 20

Contents Two-Post Center-Mount Rack Kit Installation Marking the Rack Rack Kit ContentsRecommended Tools and Supplies Attaching the Brackets Two-Post Open-Frame Relay Rack 1-U Hole SpacingTwo-Post Flush-Mount Rack Kit Installation Installing the System in the RackRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Inner Rails on the System Chassis Installing the Bracket in the RackInstalling the System in the Rack Securing the Inner Rails to the System ChassisSecuring the Computer System in the Rack Four-Post Rack Kit Installation Four-Post Rack Kit Contents Before You BeginRemoving the Doors From the 42-U Rack Installing the Rack KitRecommended Tools and Supplies Opening the 42-U Rack Door Removing the Doors From the 24-U Rack Removing the 42-U Rack DoorsUnlocking the 24-U Rack Door Installing the Slide Assemblies in the Rack Removing the 24-U Rack DoorsOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Cable-Management Arm Installing the Computer in the RackInstalling the Cable-Management Arm Replacing the Rack Doors on a 24-U Rack Replacing the Rack DoorsReplacing the Rack Doors on a 42-U Rack