Windster 100 manual Attaching the Brackets, Two-Post Open-Frame Relay Rack 1-U Hole Spacing

Page 3

.5 inch

.625 inch

1.75 inch (1 U)

.625 inch

.5 inch

Figure 2. Two-Post Open-Frame Relay Rack 1-U Hole Spacing

Attaching the Brackets

1.Locate one of the two brackets and align it over the two threaded holes on the side of the system (see Figure 3).

2.Secure the bracket to the system chassis using two 10-24 x 0.375-inch screws (see Figure 3).

Repeat this step to install the remaining bracket on the other side of the system.

support.dell.com

Dell PowerApp 100 Appliances Rack Installation Guide

3

Image 3

Contents Two-Post Center-Mount Rack Kit Installation Rack Kit Contents Recommended Tools and SuppliesMarking the Rack Two-Post Open-Frame Relay Rack 1-U Hole Spacing Attaching the BracketsInstalling the System in the Rack Two-Post Flush-Mount Rack Kit InstallationRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Bracket in the Rack Installing the Inner Rails on the System ChassisSecuring the Inner Rails to the System Chassis Installing the System in the RackSecuring the Computer System in the Rack Four-Post Rack Kit Installation Before You Begin Four-Post Rack Kit ContentsInstalling the Rack Kit Recommended Tools and SuppliesRemoving the Doors From the 42-U Rack Opening the 42-U Rack Door Removing the 42-U Rack Doors Removing the Doors From the 24-U RackUnlocking the 24-U Rack Door Removing the 24-U Rack Doors Installing the Slide Assemblies in the RackOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Computer in the Rack Installing the Cable-Management ArmInstalling the Cable-Management Arm Replacing the Rack Doors Replacing the Rack Doors on a 42-U RackReplacing the Rack Doors on a 24-U Rack