Windster 100 Installing the Bracket in the Rack, Two-Post Open-Frame Relay Rack 1-U Hole Spacing

Page 7

2.Place the 1-U template over the front of the two-posts of the rack in the desired location.

3.Position the bottom of the template in line with the desired bottom position of the computer chassis.

4.Mark the upper and lower-mounting positions on the vertical rails as shown by the V-notches on the sides of the template.

Each 1-U (1.75-inch) vertical space has three holes, with center-to-center spacing between holes (beginning at the center of the top hole of a 1-U space) 0.625, 0.625, and 0.5 inches (see Figure 5).

.5 inch

.625 inch

1.75 inch (1 U)

.625 inch

.5 inch

Figure 5. Two-Post Open-Frame Relay Rack 1-U Hole Spacing

Installing the Bracket in the Rack

CAUTION: The 1-U mounting bracket is designed to support a single PowerApp 100 system. Do not attempt to install any other system in this bracket. Damage to the system and personal injury may result.

CAUTION: Due to the size and weight of the PowerApp 100 system, never attempt to install the system by yourself.

1.Slide the back portion of the bracket to its widest opening and place the mount- ing bracket into the rack, with the bottom of the bracket at the marks you made earlier (see Figure 6).

support.dell.com

Dell PowerApp 100 Appliances Rack Installation Guide

7

Image 7
Contents Two-Post Center-Mount Rack Kit Installation Recommended Tools and Supplies Rack Kit ContentsMarking the Rack Two-Post Open-Frame Relay Rack 1-U Hole Spacing Attaching the BracketsInstalling the System in the Rack Two-Post Flush-Mount Rack Kit InstallationRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Bracket in the Rack Installing the Inner Rails on the System ChassisSecuring the Inner Rails to the System Chassis Installing the System in the RackSecuring the Computer System in the Rack Four-Post Rack Kit Installation Before You Begin Four-Post Rack Kit ContentsRecommended Tools and Supplies Installing the Rack KitRemoving the Doors From the 42-U Rack Opening the 42-U Rack Door Removing the 42-U Rack Doors Removing the Doors From the 24-U RackUnlocking the 24-U Rack Door Removing the 24-U Rack Doors Installing the Slide Assemblies in the RackOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Computer in the Rack Installing the Cable-Management ArmInstalling the Cable-Management Arm Replacing the Rack Doors on a 42-U Rack Replacing the Rack DoorsReplacing the Rack Doors on a 24-U Rack