Windster 100 manual Using Template to Mark Vertical Rails

Page 19

1 U (1.75 inches) between slide assemblies (drawing is not to scale)

1-U template

Figure 15. Using Template to Mark Vertical Rails

3.At the front of the rack cabinet, position one of the slide assemblies so that its mounting-bracket flange fits between the marks or tape you placed on the rack, marking the upper and lower edges of the template (see Figure 16). The hooks on the bottom of the mounting bracket should enter the holes beside the lower marks you made in the vertical rails.

4.Secure the front of the mounting-bracket flange with a 10-32 x 0.5-inch pan-head Phillips screw in the front vertical rail (see Figure 16).

5.Push back on the back mounting-bracket flange until the mounting hook locks into the matching square hole on the back vertical rail.

6.Repeat steps 3 through 5 for the remaining slide assembly on the other side of the rack.

support.dell.com

Dell PowerApp 100 Appliances Rack Installation Guide

19

Image 19

Contents Two-Post Center-Mount Rack Kit Installation Recommended Tools and Supplies Rack Kit ContentsMarking the Rack Two-Post Open-Frame Relay Rack 1-U Hole Spacing Attaching the BracketsInstalling the System in the Rack Two-Post Flush-Mount Rack Kit InstallationRack Kit Contents Two-Post Flush-Mount Rack Kit Contents Installing the Bracket in the Rack Installing the Bracket in the Rack Installing the Inner Rails on the System ChassisSecuring the Inner Rails to the System Chassis Installing the System in the RackSecuring the Computer System in the Rack Four-Post Rack Kit Installation Before You Begin Four-Post Rack Kit ContentsRecommended Tools and Supplies Installing the Rack KitRemoving the Doors From the 42-U Rack Opening the 42-U Rack Door Removing the 42-U Rack Doors Removing the Doors From the 24-U RackUnlocking the 24-U Rack Door Removing the 24-U Rack Doors Installing the Slide Assemblies in the RackOne Rack Unit Using Template to Mark Vertical Rails Installing the Slide Assemblies Installing the Inner Rails Installing the Computer in the Rack Installing the Cable-Management ArmInstalling the Cable-Management Arm Replacing the Rack Doors on a 42-U Rack Replacing the Rack DoorsReplacing the Rack Doors on a 24-U Rack