Uniden XSA660, XSA650 manual Important Safety Instructions

Page 10

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, these basic safety precautions should always be followed to reduced the risk of fire, electrical shock, and injury to persons:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Unplug this product from the wall outlet before cleaning, and use a dry cloth, without liquid or aerosol cleaners.

4.Do not use this product near water; for example, near a bath tub, shower, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.

5.Do not place this product on an unstable stand, or table. The telephone may fall, causing serious damage to the unit.

6.Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect the product from overheating, these openings must not be blocked or covered. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

7.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your dealer or local power company.

8.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be damaged by persons walking on it.

9.Do not overload wall outlets and extension cords, as this can result in the risk of fire or electrical shock.

10.Never push objects of any kind into this product through cabinet slots, as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electrical shock. Never spill liquid of any kind on the product.

11.To reduce the risk of electric shock, do not disassemble this product. Take it to qualified service personnel when service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks.

Incorrect reassembly can cause electric shock when the appliance is subsequently used.

12.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A.When the power supply cord is damaged or frayed.

B.If Liquid has been spilled into the product.

C.If the product has been exposed to rain or water.

D.If the product does not operate normally when following the operating instructions.(Adjust only those controls that are covered by the

4

Page 9 Page 11
Image 10
Page 9 Page 11
Contents XSA660 XSA650 Model XSA660 Controls and FunctionsModel XSA650 Handset Retainer holds handset in base for Wall Mounting Plug the battery into each handset Important NotePrerecorded outgoing message will play Press the talk buttonDial the number and make the call Press the play button on the baseContents Included in Your Package Registration CardTelephone Line Problems RangePrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions Radio Interference More Than One Cordless TelephoneWelcome FeaturesUltraClear Plus innovative technology, together with 10 AUS Installing InstallationDesk or Tabletop Installation Wall InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Setting the Handset Earpiece Volume Setting UP Your PhoneRinger Tone and Volume Raising the AntennaContinuous Battery Charging Installing the Battery PackReplace the battery cover Charging the HandsetDuring a call Standby Mode Low Battery IndicatorCleaning the Battery Contacts Automatic Digital Code Security Using Your Phone UsingMaking and Receiving Calls Changing Channels, Flash Entering a Pause in Memory Dialling Storing a Number in MemoryDialing a Stored Number Erasing a Stored Number Chain DiallingReplacing a Stored Number Call Transfer XSA660 only Setting the Handset Number XSA660 onlyWay Conference Press skip or repeat until the correct day is announced Setting the ClockTo turn the Answering System on, press answer Press clock to return to StandbySelecting a Preset OGM Setting your Outgoing Message OGMPreset Messages Reviewing Time and Day StampSetting the Toll Saver Switch Can hang up after the second ring and not be billedWhen all messages have played, a long tone sounds Playing New MessagesRepeating a Message Base Operation Skipping a Message Base OperationDeleting all Messages Message Full IndicationScreening Incoming Calls Leaving a Memo MessageRemote Operation Setting Your PIN CodeUsing a Touch-Tone Phone Function PressTroubleshooting Trouble ShootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited
Top Page Image Contents