Uniden XSA660 manual Installing the Battery Pack, Replace the battery cover, Charging the Handset

Page 18

The battery connector will fit together only one way. Make sure the connector is properly aligned. Use only the Uniden battery pack (model BT-434)

Replace the handset on the base after use if convenient. However recharging the battery is only necessary when the low battery indicator is lit. On a monthly basis use the phone until the low battery indicator appears. Then charge the battery for 15-20 hours.

Installing the Battery Pack

The rechargeable Nickel-Cadmium battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must charge the battery for approximately 15-20 hours without interruption.

1.Remove the Handset battery cover.

2.Plug the battery’s cable into the handset and place the battery pack inside the battery compartment.

3.Replace the battery cover.

Charging the Handset

1.Place the handset on the base to charge. (The handset will charge only in the face-down position.) OR place the handset on the charger keypad facing forward (XSA660 only).

(Spare Handset - XSA660 only)

2.Make sure the status LED lights on the base or change LED lights on the charger. If the LED doesn’t light, check to see that the AC Adaptor is plugged in and switched on. Also that the Handset is making good contact with the Base Unit and charger charging contacts.

Continuous Battery Charging

For the best battery performance, return the Handset to the Base Unit at the end of the day. This keeps the battery fully charged.

12

Image 18

Contents XSA660 XSA650 Controls and Functions Model XSA660Model XSA650 Handset Retainer holds handset in base for Wall Mounting Plug the battery into each handset Important NotePrerecorded outgoing message will play Press the talk buttonDial the number and make the call Press the play button on the baseContents Included in Your Package Registration CardTelephone Line Problems RangePrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions Radio Interference More Than One Cordless TelephoneFeatures WelcomeUltraClear Plus innovative technology, together with 10 AUS Installing InstallationDesk or Tabletop Installation Wall InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Setting the Handset Earpiece Volume Setting UP Your PhoneRinger Tone and Volume Raising the AntennaContinuous Battery Charging Installing the Battery PackReplace the battery cover Charging the HandsetLow Battery Indicator During a call Standby ModeCleaning the Battery Contacts Automatic Digital Code Security Using Using Your PhoneMaking and Receiving Calls Changing Channels, Flash Storing a Number in Memory Entering a Pause in Memory DiallingDialing a Stored Number Chain Dialling Erasing a Stored NumberReplacing a Stored Number Setting the Handset Number XSA660 only Call Transfer XSA660 onlyWay Conference Press skip or repeat until the correct day is announced Setting the ClockTo turn the Answering System on, press answer Press clock to return to StandbySelecting a Preset OGM Setting your Outgoing Message OGMPreset Messages Reviewing Time and Day StampSetting the Toll Saver Switch Can hang up after the second ring and not be billedWhen all messages have played, a long tone sounds Playing New MessagesRepeating a Message Base Operation Skipping a Message Base OperationDeleting all Messages Message Full IndicationScreening Incoming Calls Leaving a Memo MessageRemote Operation Setting Your PIN CodeUsing a Touch-Tone Phone Function PressTroubleshooting Trouble ShootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited