Uniden XSA650, XSA660 manual Deleting all Messages, Message Full Indication

Page 31

Deleting a Message
Base Operation
1.	Press play/stop	■ ▼		to review your messages.

2.	If you decide to delete a message, press and
	release delete	Ø	anytime during the message.

The system beeps and immediately goes to the next message.

Note: When you press delete you are deleting the message. Once the message is deleted, it cannot be replayed.

status

deleteplay/stop

Ø	■ ▼
repeat ogm memo	skip
▼ ▼	▼ ▼

3. You will hear a long tone on the Base speaker.

Deleting all Messages

You can delete all your messages without deleting each separate message. To delete all the messages, you must use the delete button on the Base Unit.

1. Press and hold delete	Ø	for at least 3 seconds	status

2. A long tone sounds once the messages are erased.

delete

Ø

play/stop

■ ▼

repeat ogm memo skip

▼ ▼

▼ ▼

Message Full Indication

The XSA660 or XSA650 has a maximum record time of 15 minutes or up to 59 incoming message. When the memory is full, the Answering System will not record incoming calls. To return the system to normal operation, follow these steps.

1.When the memory is full, the phone will ring 15 times before the announcement “No remaining time” plays.

2.You must review your messages and then delete some or all of the stored messages.

25

Image 31

Contents XSA660 XSA650 Model XSA660 Controls and FunctionsModel XSA650 Handset Retainer holds handset in base for Wall Mounting Important Note Plug the battery into each handsetPress the play button on the base Press the talk buttonDial the number and make the call Prerecorded outgoing message will playContents Registration Card Included in Your PackageRange Telephone Line ProblemsPrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions More Than One Cordless Telephone Radio InterferenceWelcome FeaturesUltraClear Plus innovative technology, together with 10 AUS Installation InstallingWall Installation Desk or Tabletop InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Raising the Antenna Setting UP Your PhoneRinger Tone and Volume Setting the Handset Earpiece VolumeCharging the Handset Installing the Battery PackReplace the battery cover Continuous Battery ChargingDuring a call Standby Mode Low Battery IndicatorCleaning the Battery Contacts Automatic Digital Code Security Using Your Phone UsingMaking and Receiving Calls Changing Channels, Flash Entering a Pause in Memory Dialling Storing a Number in MemoryDialing a Stored Number Erasing a Stored Number Chain DiallingReplacing a Stored Number Call Transfer XSA660 only Setting the Handset Number XSA660 onlyWay Conference Press clock to return to Standby Setting the ClockTo turn the Answering System on, press answer Press skip or repeat until the correct day is announcedReviewing Time and Day Stamp Setting your Outgoing Message OGMPreset Messages Selecting a Preset OGMCan hang up after the second ring and not be billed Setting the Toll Saver SwitchPlaying New Messages When all messages have played, a long tone soundsSkipping a Message Base Operation Repeating a Message Base OperationMessage Full Indication Deleting all MessagesLeaving a Memo Message Screening Incoming CallsFunction Press Setting Your PIN CodeUsing a Touch-Tone Phone Remote OperationTrouble Shooting TroubleshootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited