Uniden XSA650 Setting the Handset Number XSA660 only, Call Transfer XSA660 only, Way Conference

Page 25

Call transfer will not operate if the handset number has not been set.

Setting the Handset Number - XSA660 ONLY

Note: An error tone will sound and the programming procedure will be cancelled if more than 20 seconds elapse between each keystroke entry or step.

1.Remove the Handset from the Base Unit or from the charger.

2.Press mem. The talk/batt low LED blinks.

3.Press trans

4.Enter the number you want to store to the Handset (1 or 2).

Note: If you stored the same number to each Handset, you can not transfer between Handsets.

5. Press mem again.

A tone indicates that the Handset number is stored. (Default Handset number: 1)

Call Transfer - XSA660 ONLY

Call can be transferred between Handsets.

1.Press trans the other Handset will ring. The other Handset must be in Standby mode to receive paging.

2.Press talk on the other Handset and the call is transferred from Handset 1 to 2.

3.If the Handset on the Base or charger, pick up the Handset (AutoTalk)

4.If the transfer is not picked up by the Handset, then after 60 seconds it will return to the originating Handset.

3 Way Conference

During Handset talk mode, press the speaker button on the Base then you can talk 3 ways. If you are already using the Base speaker phone, press the talk button on one Handset.

19

Image 25

Contents XSA660 XSA650 Model XSA660 Controls and FunctionsModel XSA650 Handset Retainer holds handset in base for Wall Mounting Important Note Plug the battery into each handsetDial the number and make the call Press the talk buttonPrerecorded outgoing message will play Press the play button on the baseContents Registration Card Included in Your PackageRange Telephone Line ProblemsPrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions More Than One Cordless Telephone Radio InterferenceWelcome FeaturesUltraClear Plus innovative technology, together with 10 AUS Installation InstallingWall Installation Desk or Tabletop InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Ringer Tone and Volume Setting UP Your PhoneSetting the Handset Earpiece Volume Raising the AntennaReplace the battery cover Installing the Battery PackContinuous Battery Charging Charging the HandsetDuring a call Standby Mode Low Battery IndicatorCleaning the Battery Contacts Automatic Digital Code Security Using Your Phone UsingMaking and Receiving Calls Changing Channels, Flash Entering a Pause in Memory Dialling Storing a Number in MemoryDialing a Stored Number Erasing a Stored Number Chain DiallingReplacing a Stored Number Call Transfer XSA660 only Setting the Handset Number XSA660 onlyWay Conference To turn the Answering System on, press answer Setting the ClockPress skip or repeat until the correct day is announced Press clock to return to StandbyPreset Messages Setting your Outgoing Message OGMSelecting a Preset OGM Reviewing Time and Day StampCan hang up after the second ring and not be billed Setting the Toll Saver SwitchPlaying New Messages When all messages have played, a long tone soundsSkipping a Message Base Operation Repeating a Message Base OperationMessage Full Indication Deleting all MessagesLeaving a Memo Message Screening Incoming CallsUsing a Touch-Tone Phone Setting Your PIN CodeRemote Operation Function PressTrouble Shooting TroubleshootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited