Uniden XSA650, XSA660 manual Or 1-minute position Does not

PROBLEM		SUGGESTION
Base Unit	● Set the Base Unit Ringer switch to ON.
doesn’t ring
	● Make sure the base unit is plugged in.
Answering System	●	Make sure the Answering System is turned ON.
does not work.	●	Disconnect the AC adaptor to reset the phone.
Answering System	● Set the REC TIME/ANN/4/1 switch in either the 4-minute
		or 1-minute position.
does not
		The memory may be full. Delete some or all of the saved
answer calls.	●
		messages.
	● The incoming messages may be too long. Remind callers
Message are		to leave a brief message.
incomplete.	●	The memory may be full. Delete some or all of the saved
		messages.
After a power	● The answering machine has a flash memory with no
		battery backup. Record your personal outgoing message
failure, the outgoing
		again. The incoming messages should still remain.
message is deleted.
			TROUBLESHOOTING
remote call-in	●	Make sure that the touch-tone phone you’re using can
Message counter	●	There has been a power failure. Press Reset to reset the
LED flashes 88		Answering System.
No sound on the	● Adjust the volume control on the Base Unit
Base Unit Speaker
Cannot access	● Make sure you’re using the correct PIN code.
feature from another		transmit the tone for at least two seconds. If it cannot, you
touch-tone phone		may have to change to another phone
Cannot record	● The memory may be full. Delete some or all of the saved
		messages
outgoing message
Clock losses time	● The power to the base unit has been interrupted. Reset the
		clock as detailed on page 21 of this owner’s manual.

29