Uniden XSA660, XSA650 manual Mounting Directly on a Wall

Page 16

Use only the AC adaptor that came with the phone.

10

Mounting Directly on a Wall

If you do not have a standard wall plate, you can mount the phone directly on a wall. Before mounting your cordless telephone, consider the following:

Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

Make sure the wall material is capable of supporting the weight of the base and handset; otherwise, damage to the unit could result.

Use #10 screws with anchoring devices suitable for the wall material where the base will be placed.

1.Insert the screws, with their appropriate anchoring devices, 100mm apart. Allow 5mm between the wall and screw heads for mounting the phone.

1

2.Fit the Wall Mounting Adaptor to the telephone Base.

3.Plug the AC adaptor into the base.

4.Place the AC adaptor cord inside the left molded channel cord holder.

5.Plug one end of the long telephone cord into the TEL LINE jack on the base.

6.Place the telephone cord into the right molded channel cord holder.

7.Place the base on the screws and push down until it’s firmly seated.

8.Plug the other end of the telephone line into the telephone wall jack. (Remember; the phone must be fully charged before you can use it.)

	9. Plug the AC adaptor into a standard	10
	240V AC wall outlet.	10
	240V AC wall outlet.
	10. Fully extend the antenna on the base.	3 5

7	4	6
		6
		2
		8
9		Line in

From

Telephone

Jack

AC

Adaptor

Image 16

Contents XSA660 XSA650 Model XSA660 Controls and FunctionsModel XSA650 Handset Retainer holds handset in base for Wall Mounting Plug the battery into each handset Important NotePress the talk button Dial the number and make the callPrerecorded outgoing message will play Press the play button on the baseContents Included in Your Package Registration CardTelephone Line Problems RangePrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions Radio Interference More Than One Cordless TelephoneWelcome FeaturesUltraClear Plus innovative technology, together with 10 AUS Installing InstallationDesk or Tabletop Installation Wall InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Setting UP Your Phone Ringer Tone and VolumeSetting the Handset Earpiece Volume Raising the AntennaInstalling the Battery Pack Replace the battery coverContinuous Battery Charging Charging the HandsetDuring a call Standby Mode Low Battery IndicatorCleaning the Battery Contacts Automatic Digital Code Security Using Your Phone UsingMaking and Receiving Calls Changing Channels, Flash Entering a Pause in Memory Dialling Storing a Number in MemoryDialing a Stored Number Erasing a Stored Number Chain DiallingReplacing a Stored Number Call Transfer XSA660 only Setting the Handset Number XSA660 onlyWay Conference Setting the Clock To turn the Answering System on, press answerPress skip or repeat until the correct day is announced Press clock to return to StandbySetting your Outgoing Message OGM Preset MessagesSelecting a Preset OGM Reviewing Time and Day StampSetting the Toll Saver Switch Can hang up after the second ring and not be billedWhen all messages have played, a long tone sounds Playing New MessagesRepeating a Message Base Operation Skipping a Message Base OperationDeleting all Messages Message Full IndicationScreening Incoming Calls Leaving a Memo MessageSetting Your PIN Code Using a Touch-Tone PhoneRemote Operation Function PressTroubleshooting Trouble ShootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited