Uniden XSA650 Remote Operation, Setting Your PIN Code, Using a Touch-Tone Phone, Function Press

Remote Operation

You can operate your XSA660 or XSA650 you’re away from home by calling from any touch-tone phone. When using this feature, remember these important guidelines.

•You should change your Personal Identification Number (PIN) before using your phone. When you first apply power, the code is set to 80.

•You cannot change the Time and Day Stamp or your PIN code from a touch- tone phone.

Setting Your PIN Code

Using the phone, you can set a personal two digit code (00 to 99) for your PIN code. You must use your PIN code to access your Answering System from a touch- tone telephone.

1.	Press and hold pin. The [ 00] display on the Base.			repeat	ogm	memo	skip
2.	Press skip ▼▼ or repeat	▼ ▼	to select the	▼ ▼			▼ ▼
				pin	clock	answer	page
	first digit of four pin numbers.
3.	Press pin again.
4.	Press skip ▼▼ or repeat	▼ ▼	to select the next digit of your pin
	number.

5.Press pin again.

You will hear a long tone which indicates that the new code is saved.

Remember to press # before each command number.

Using a Touch-Tone Phone

You can operate your Answering System using any touch-tone phone. Use this function to check for recorded messages, play or delete messages, or even record a new outgoing message.

1.Call your telephone number.

2.During the outgoing message playback, press # followed by your PIN number.

3.The Answering System announces the Time and Day Stamp. The number of messages stored in memory follows.

4.Use this chart to select the function you want.

Function Press

Repeat	#1
Play Message	#2
Skip	#3
Delete Message	#4
Stop	#5
Answer ON	#6
Memo Rec/Memo Rec Stop #7
Ogm Rec/ogm Rec Stop	#8
Answer OFF	#9
Room Monitor	#,*

Note: You must enter a command within 2 seconds or the Answering System hangs up and returns to Standby.

5.When you’ve finished, hang up to exit the system.

Your Answering System automatically returns to Standby.

27