Uniden XSA650 Low Battery Indicator, During a call Standby Mode, Cleaning the Battery Contacts

Page 19

The built-in Memory Backup feature allows up to 1 minute to disconnect the old battery pack and install a new one without losing any numbers stored in memory.

	Low Battery Indicator
	When the battery pack in the handset is low and needs		trans
	to be charged, the talk/batt LED flashes once every		trans
	to be charged, the talk/batt LED flashes once every
	3 seconds.
	If this occurs while you are on the phone, you will
	hear an alert tone. Complete your call as quickly as
	possible, and return the handset to the base for charging.
	During a call	In Standby Mode
	Only the talk button operates.	None of the buttons will operate.
	The Handset beeps and the talk/batt	The Handset talk/batt low LED flashes
	low LED flashes once every 3 seconds.	once every 3 seconds.
	Complete your call as quickly as	You will not be able to make a call.
	possible.
	Return the Handset to the Base Unit	Return the Handset to the Base Unit
	for charging.	for charging.

Cleaning the Battery Contacts

To maintain a good charge, it is important to clean all battery contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner. Do not use any liquids or solvents, or abrasive materials.

▼ ▼	▼ ▼
pin	clock answer page

mic

▼

contacts

(Spare charging cradle - XSA660 only)

13

Image 19

Contents XSA660 XSA650 Model XSA660 Controls and FunctionsModel XSA650 Handset Retainer holds handset in base for Wall Mounting Important Note Plug the battery into each handsetPress the play button on the base Press the talk buttonDial the number and make the call Prerecorded outgoing message will playContents Registration Card Included in Your PackageRange Telephone Line ProblemsPrecautions PrecautionsRechargeable Nickel-Cadmium Battery Warning Important Safety Instructions More Than One Cordless Telephone Radio InterferenceWelcome FeaturesUltraClear Plus innovative technology, together with 10 AUS Installation InstallingWall Installation Desk or Tabletop InstallationMounting on a Standard Wall Plate Mounting Directly on a Wall Raising the Antenna Setting UP Your PhoneRinger Tone and Volume Setting the Handset Earpiece VolumeCharging the Handset Installing the Battery PackReplace the battery cover Continuous Battery ChargingDuring a call Standby Mode Low Battery IndicatorCleaning the Battery Contacts Automatic Digital Code Security Using Your Phone UsingMaking and Receiving Calls Changing Channels, Flash Entering a Pause in Memory Dialling Storing a Number in MemoryDialing a Stored Number Erasing a Stored Number Chain DiallingReplacing a Stored Number Call Transfer XSA660 only Setting the Handset Number XSA660 onlyWay Conference Press clock to return to Standby Setting the ClockTo turn the Answering System on, press answer Press skip or repeat until the correct day is announcedReviewing Time and Day Stamp Setting your Outgoing Message OGMPreset Messages Selecting a Preset OGMCan hang up after the second ring and not be billed Setting the Toll Saver SwitchPlaying New Messages When all messages have played, a long tone soundsSkipping a Message Base Operation Repeating a Message Base OperationMessage Full Indication Deleting all MessagesLeaving a Memo Message Screening Incoming CallsFunction Press Setting Your PIN CodeUsing a Touch-Tone Phone Remote OperationTrouble Shooting TroubleshootingOr 1-minute position Does not Specifications SpecificationsWarranty WarrantyUniden Australia Pty Limited Uniden New Zealand Limited