BASIC FUNCTIONS | GENERAL INFORMATION |
English
SWITCHING ON AND OFF
•Adjust the POWER slider to the desired sound source: CD, TUNER or TAPE.
•The set is switched off when the POWER slider is in the TAPE/OFF position and the buttons on the tape deck are released.
–The volume, sound settings and tuner presets will be retained in the set's memory.
|
|
|
| CD | SYNCROREWRITABLE |
SO |
| M |
| CD | |
| OLU |
|
| ||
UND |
| V |
|
| |
| CONTR OL CENTER |
|
| STRAT R | |
|
|
| AZ | 1575 |
|
| STOP |
|
|
| |
| PLAY• |
|
|
| |
|
|
|
|
| |
|
| PAUSE |
|
|
|
ADJUSTING VOLUME AND SOUND
1.Turn the VOLUME/ SOUND CONTROL CENTER control clockwise to increase or
the set (or press VOLUME + or – on the remote control).
™Display shows the volume level indication VOL and a number from
2.To adjust the bass, mid and high frequency levels, press DIGITAL EQUALIZER once or more until the desired option is displayed. While the option is shown, turn the VOLUME/ SOUND
CONTROL CENTER control to increase or decrease (- 5 to + 5 maximum) the desired frequency.
™VOLUME can also be adjusted in this way with a level range from
3.Press DIGITAL DBB to switch dynamic bass boost on or off. ™ If on, the DIGITAL DBB light goes on.
4.Press INCREDIBLE SURROUND to switch the surround sound
effect on or off.
™If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with different types of music.
|
|
|
|
| CD | RE |
|
|
| M |
| CD | |
SO |
|
| OLU |
|
| SY |
UND | CONTR OL CENTER | V |
|
|
| |
|
|
|
| AZ | 1575 |
|
| STOP |
|
|
|
| |
| PLAY• |
|
|
| ||
|
|
| PAUSE |
|
|
|
| PRO | LBAT | SOUND CO |
|
|
+
•
•
•
•
0
•
•
•
•
–
VOL
GENERAL INFORMATION
General maintenance
•Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
•To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
Safety information
•Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating.
•The mechanical parts of the set contain
10