JVC DR-MV5S manual Advanced Recording VHS, Free Rate Function, VHS TV Input Reset, Disc space

Page 60

60 EN ADVANCED RECORDING

 

 

 

 

 

 

 

 

 

 

Free Rate Function

 

 

Advanced Recording (VHS)

 

 

 

 

 

 

To record the entire program, the unit automatically sets the

 

 

 

 

 

 

 

 

appropriate recording mode depending on the combination of the

 

 

 

 

total time of the program to be recorded and either the remaining

 

Turn on the unit.

disc space or the specified recording time (from 60 minutes to 480

 

Turn on the TV and select the AV mode.

minutes).

 

Slide the TV/DVD switch to DVD.

8 To record the entire program within the actual remaining

 

Press VHS so that the VHS lamp lights up on the unit.

disc space

Select “FR (JUST)” in a recording mode selection procedure.

Note that this function is available only for timer programing recording ( pg. 31, 32).

8 To record the entire program by specifying the desired recording time

Select “FR60–FR360”, “FR420” or “FR480” in a recording mode

STANDBY/ON

VHS

DVD

REC

 

 

VHS/DVD

CH

S-VIDEO

VIDEO

AUDIO

 

 

 

 

VHS

DUBBING

DVD

selection procedure. ( pg. 28, 31, 32)

8 To record a 25-min. long daily program five times just on the same DVD disc for example

Perform “VCR Plus+® Timer Programing” ( pg. 31) procedure. Be sure to set the recording mode to “FR125” and set Weekly/Daily Rec Function to “MON–FRI” in step 6 to fit the total recording time to the whole disc space.

A: 1st

B: 2nd

Blank C: 3rd

D: 4th

E: 5th

VHS

DV IN

TV INPUT

C.RESET

CH +/–

When the same program is recorded in SP mode instead of in “FR125”, the 5th program cannot be recorded.

Blank

A:1st

B:2nd

C:3rd

D:4th

E:Blank (20 min.)

NOTES:

You can program this unit to timer-record, regardless of the disc remaining time. When the disc remaining time is not enough,

recording may stop in the middle of a program. To avoid this, makeDISPLAY sure of the disc remaining time before setting timer programing.

(Example) If you programed to timer-record for 60 minutes in SP mode on a 120-minute disc, the disc remaining time would be 30 minutes in XP mode, 60 minutes in SP mode, 120 minutes in LP mode, 180 minutes in EP mode, and 240 minutes in FR480 mode. Timer-recording will not complete beyond these remaining times.

The maximum recording time of “FR (JUST)”mode is the same as the

recording time of FR480 mode. When timer programing a long program in “FR (JUST)”mode on a disc whose remaining time is short, it is recommended to check the disc remaining time in FR480 mode to see if the remaining time is enough for the program.

Even if more than one program are timer programed in “FR (JUST)” mode, only the first one is recorded.

In order to ensure that the recording fits on the disc, this feature may leave a slight non-recorded section at the end of the disc.

There may be some noise and sound disturbance at the point on the disc where the unit switches the mode.

Image 60
Contents DR-MV5S For Customer UseDear Customer This unit should be used with AC 120Vd, 60Hz onlyPower Lines Power SourcesPower Cord Protection Outdoor Antenna GroundingAccessories CleaningDamage Requiring Service Replacement PartsDeclaration of Conformity Do not place the unitDo not block the unit’s ventilation openings or holes To mobile phone usersEnjoying your life with Enjoy the vivid picture quality DVD recording/playbackRecorder About Discs Recordable/Playable DiscsDiscs For Playback Only DVD-RAM DiscsRecording Medium And Format Unplayable DiscsFile Structure Of Discs Region NumberDVD Video Marks Audio CD/Video CDMarks related to video File structure of a disc before starting the MP3/JPEGPlacing a Disc Care And Handling Of DiscsFront View Rear ViewWhen a disc is loaded, the type of the disc is indicated Lights when a DVD-RW disc is formatted in VR modeLeft 3 digits of Multi Display S indicate the audio mode Front Display PanelHow To Use  pgOn-Screen Display DVD deck only Connections Composite Connection Without Cable Box Or DBS ReceiverIt’s essential that your unit be properly connected Composite Connection With Cable Box Or DBS Receiver Back of unitComponent Video Connection What to do if Plug & Play setting failed Plug & Play SetAuto Clock Set/Auto Tuner Set SET UP LanguageDVD EnterClock Set Semiauto Clock SetManual Clock Set Auto Daylight Saving TimeTuner Set Manual Channel SetAuto Channel Set Monitor Set Pan&Scan/Letter BoxPan&Scan Letter BoxAbout recording mode PlaybackWant to do? Basic Playback DVD Load a discClean the video heads using a dry cleaning cassette when Basic Playback VHSUsable cassettes Compact VHS camcorder recordings can be played on thisBasic Recording DVD Press 8 to stop recordingRecording Mode Mode Approx Time approxRecording Resume Function Recording Recording amountBasic Recording VHS MaximumUse Timer Programing CancelTimer VHSManual Timer Programing Timer-record the programVHS DVD To Make The Disc For On-Disc Timer Programing To Timer-record The Program With The Programed DiscOnly Cable Box and DBS Receiver UsersHow Discs Are Overwritten Check, Cancel And Change Programs When Programs Overlap Each OtherREC Link Program’s information on the front display panelREC Mode DVD Deck OnlyDVD REC Link Auto Recording Mode Optimizer Stop and pause mode on the DVD deckAuto Title Creation Dubbing Auto Blank-Cut DubbingDubbing a Part Of a Cassette VHS/DVD VHS DubbingREC Mode Progressive Scan Dubbing An Entire DiscVHS/DVD Dubbing Dubbing a Part Of a Disc VHS/DVD Dubbing DVDPerforming dubbing without using the DV Dubbing controller DV Dubbing DVD Deck OnlyIf the camcorder has no S-VIDEO output connector Edit From a CamcorderSlide the TV/DVD switch to DVD When recording on DVD deckWhen recording on VHS deck Edit From Another RecorderDigital Audio Dubbing Example Dubbing to an MDAdvanced Playback DVD High-Speed SearchDVD TOP Menu Enter MenuResume Function Still Picture/Frame-By-Frame PlaybackSlow Motion Skip SearchAngle Selection Subtitle Selection Checking The Time InformationAudio Channel Selection On-Screen DisplayPBC appears on the front display panel Pressing Next 6 advances to the nextRecording/playback Status Display DisplayOverview Of Live Memory Playback Recording screen Live Memory Playback screenDisplay During Live Memory Playback Available only when paused To Watch a Program Previously Recorded While RecordingButtons To Be Used During Live Memory Playback Using The On-screen Bar How To Access The On-screen BarBasic Operation On The On-screen Bar RtweRepeat Playback Return On ScreenAdjusting The Picture Quality Setting The Progressive ModeTime Search To select track 5, press the number buttonCancel Enter Select The Switching Interval Of The Slide ShowRandom Playback Program PlaybackAdvanced Playback VHS Quick Rewind a LittleIndex Search CH +Next Function Memory Manual TrackingVHS Progressive Scan Soundtrack SelectionInstant Timer Recording ITR Advanced Recording DVDElapsed Recording Time And Disc Remaining Time Indication Second Audio RecordingVHS TV Input Reset Advanced Recording VHSFree Rate Function Disc spaceElapsed Recording Time Indication Tape Remaining TimeActive Video Calibration PlaybackLibrary Database DVD Navi Display for original Display for play list RecordingIcons and their meanings Modify Original Information Scan For Beginning Of TitleModify Index MemoModify Title Name Delete Unwanted Part Of The TitleModify Category Protect TitleModify Play List Information Add Scenes To a Play ListCreate Play List Move ScenesPlay Back Play List Delete Unwanted Part From Play ListDelete Play List Modify Play List NameModify Library Information Scan For Title From LibraryRegister Disc Delete InformationLocating The Desired Group And Tracks On completion of the playback of all the itemsPress Clear Remote control setting Tips for your trouble SpecificationsWarranty Only in U.S.A For better soundRemote Control Functions Remote Control 1/2/3/4 Code SwitchingTV Multi-Brand Remote Control Enter SET UPWith built-in DTS using an optional coaxial cable Digital Decoder or an amplifier with built-in DTSMode Set DVD Deck Utility  pgOthers  pg Press rt to select 2NDWhen this function is set to on When this function is set to OFF, the SAP audio cannot beRecorded Scan Mode Set OFF You cannot use the resume functionMode Set VHS Deck VHS EnterFor Example Tray Lock DVD Deck Only To lock trayTo unlock tray Changing VCR Plus+ Setting Guide Channel Number SetPress rt to select Guide CH SET, then press EnterFormat a DVD-RW Disc Then press tAfter finalizing For DVD-R/RW Video mode discs Finalize a DVD-R/RW DiscPlayback DVD Deck Initializing DVD Deck OnlyGeneral Timer Recording DVD Deck Playback VHS DeckRecording DVD Deck Recording VHS DeckTimer Recording VHS Deck Other ProblemsPower failure occurred Set date and time correctly.  pg For composite connectionTimer recording has finished during Live Memory playback An invalid PlusCode number has been input.  pgPower requirement Power consumptionTemperature Dimensions WxHxDLanguage Code List Select The Switching Interval Of The Slide Show When Program Overlap Each OtherAudio Language/Sound Selection Elapsed Recording Time IndicationWarranty Only in U.S.A DR-MV5S