Tyco Electronics P5400 manual Sending an Individual Call, Calls Received Lists

MM-012099-001, Rev. B

Figure 8-11: Calls Received Lists

To access the Calls Received List, press the key twice. Use the or buttons to scroll through

the list. Pressing the key will display the time elapsed since the call was received. After pressing the display will appear similar to Figure 8-12.

Figure 8-12: WHC Individual Call Display

Pressing the PTT will initiate an individual call to the displayed logical ID. Powering the radio OFF and ON will clear this list.

8.22.2Sending an Individual Call

8.22.2.1 Pre-Stored Individual Calls

The following procedures describe how to initiate and complete a Pre-Stored Individual Call.

P5470 Model Radio

1.To select a pre-stored individual phone number, enter the individual call mode using the key. is displayed. Then scroll through the list of stored numbers using the or keys.

2.Press the PTT button; when the radio is clear to transmit, turns ON, turns OFF and the channel access tone sounds. Line one shows the called individual's name if found in the list of stored individuals or LID followed by the logical ID number of the unit being called. The message *INDV* displays on line two.

P5450 Model Radio

1.To select a pre-stored individual number, enter the menu mode by pressing the key. Scroll through the mode list using the or buttons.

2.Press . is displayed. Scroll through the list of stored phone numbers using the or buttons until the desired number is displayed. Press .

53