Tyco Electronics P5400 manual Error Messages

		MM-012099-001, Rev. B
MESSAGE	NAME	DESCRIPTION
	Call Denied	Indicates the radio or talkgroup is not authorized to operate on the selected
DENIED
		system and/or talkgroup.
	Control	Indicates the control channel is lost and the radio has entered the Control
CC SCAN
	Channel Scan	Channel Scan mode to search for the control channel (usually out of range
		indication).
	Wide Area	Indicates the radio has entered the Wide Area Scan mode to search for a
WA SCAN
	Scan	new system (if enabled through programming).
	System Scan	Indicates the System Scan features are enabled.
SYSC ON
	Features On
	System Scan	Indicates the System Scan features are disabled.
SYSC OFF
	Features Off
	Low Battery	Battery voltage has dropped to the point to where the radio is no longer able
LOW BATT
		to transmit. The radio will still receive calls until the battery is discharged
		beyond the point of operation at which time the radio automatically shuts
		down.
	Receive	Indicates an emergency call is being received. This message will be
RXEMER
	Emergency	flashing on line two.
	Transmit	Indicates an emergency call has been transmitted on this radio.	This
TXEMER
	Emergency	message will be flashing on line two.
	Volume Level	Indicates the current volume level. The volume level display ranges from
VOL=31
		OFF (silent) to 40 (loudest).
	Who Has	Indicates an individual call has been received, but not responded to.	The
WHC
	Called	indicator turns OFF if the individual call mode is entered, the system is
		changed, or the radio is turned off and then on again.
	Unknown ID	Indicates an individual call is being received from an unknown ID.
UNKNOWN

10.5.1Error Messages

If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs servicing.

DSP ERR	or	DIG	V	x
ERR=XXXX		ERR		x
(PowerUp
only)

Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.

89