Figure 2. Mount the SCv2080 Storage System Chassis
4.Secure the storage system chassis to the rack using
5.If the Storage Center system includes an expansion enclosure, mount the expansion enclosure above the storage system. See the instructions included with the expansion enclosure for detailed steps.
Installing the Hard Drives
Hard drives are connected to the backplane of the drawers using Disk Drive in Carrier (DDIC) hard drive carriers.
The minimum number of drives in an SCv2080 storage system is 28 (one full, front row in the top drawer and one full, front row in the bottom drawer).
1.Open the bottom drawer.
CAUTION: If the storage system operates for too long (depending on altitude) with a drawer open, the storage system may overheat, causing a power failure and data loss. Such use may invalidate the warranty.
a.Push and hold both drawer latches toward the center of the drawer.
b.Pull the drawer all the way out until it stops.
2.Insert each disk drive in carrier (DDIC) into the drawer, one at a time.
CAUTION: To maintain proper airflow, the drawers must be populated with drives in whole rows (there are three rows of 14 drives per drawer). The number of populated rows between drawers must not differ by more than one. Populate the rows from the front to the rear of the drawer.
a.Hold the DDIC vertically and slide it most of the way into the slot.
b.Using both hands, apply downward pressure firmly and equally across the DDIC.
c.While maintaining downward pressure on the DDIC, slide the top plate toward the back of the drawer until it clicks in place.
10