Dell SCv2080 manual Connecting the Power Cables

Page 17

Figure 8. SC180 Expansion Enclosure Connected to an SCv2080 Storage System

1.	SC180 expansion enclosure	2.	SCv2080 storage system
3.	Storage controller 1	4.	Storage controller 2

Connecting the Power Cables

Connect power cables to the storage system.

1.Make sure that the power switches on the storage system are in the OFF position before connecting the power cables.

2.Connect the power cables to the power supplies in the storage system chassis.

17

Image 17

Contents Dell Storage Center Page Before You Begin Safety WarningsPage Storage Center Information ISCSI Fault Domain InformationWorksheet to Record System Information Fibre Channel Zoning Information Additional Storage Center InformationOther Information You May Need Locating Your Service TagSafety Precautions Installation and ConfigurationInstallation Safety Precautions Unpacking Storage Center EquipmentSCv2080 Storage System Components Installing the Storage System in a RackMount the SCv2080 Storage System Chassis Installing the Hard DrivesDdic Cabling SAN-Attached Host Servers Front-End CablingCabling Direct-Attached Host Servers Storage System Connected to Switches and Host ServersStorage System Connected Directly to Host Servers Cabling the Ethernet Management NetworkBack-End Cabling Interconnecting Two Storage ControllersInterconnected Storage Controllers Cabling an Expansion Enclosure to a Storage SystemConnecting the Power Cables Turning on the Storage System Power CablesNOM Information Mexico Only Technical SpecificationsInstalling and Using the Dell Storage Client Page Ddic