Dell SCv2080 manual Cabling the Ethernet Management Network

Page 14

Figure 5. Storage System Connected Directly to Host Servers

 

1.

Server 1

2.

Server 2

3.

Server 3

4.

Server 4

5.

SCv2080 storage system

6.

Storage controller 1

7.Storage controller 2

Cabling the Ethernet Management Network

The Ethernet management (MGMT) interface of each storage controller must be connected to a management network.

NOTE: The left storage controller is storage controller 1 and the right storage controller is storage controller 2.

1.Connect an Ethernet cable from the MGMT port on storage controller 1 to the management network switch.

2.Connect an Ethernet cable from the MGMT port on storage controller 2 to the management network switch.

14

Image 14
Contents Dell Storage Center Page Safety Warnings Before You BeginPage Storage Center Information ISCSI Fault Domain InformationWorksheet to Record System Information Additional Storage Center Information Fibre Channel Zoning InformationLocating Your Service Tag Other Information You May NeedInstallation Safety Precautions Installation and ConfigurationSafety Precautions Unpacking Storage Center EquipmentInstalling the Storage System in a Rack SCv2080 Storage System ComponentsInstalling the Hard Drives Mount the SCv2080 Storage System ChassisDdic Front-End Cabling Cabling SAN-Attached Host ServersStorage System Connected to Switches and Host Servers Cabling Direct-Attached Host ServersCabling the Ethernet Management Network Storage System Connected Directly to Host ServersInterconnecting Two Storage Controllers Back-End CablingCabling an Expansion Enclosure to a Storage System Interconnected Storage ControllersConnecting the Power Cables Power Cables Turning on the Storage SystemNOM Information Mexico Only Technical SpecificationsInstalling and Using the Dell Storage Client Page Ddic