Wagner SprayTech 9190, 9170, 9146, 9150 Important Cleaning Notes, Cleanup Latex materials

Important Cleaning Notes!

Read these notes and warnings before you start to clean your sprayer!

•When using latex materials, clean your sprayer and components with water. When using oil-based materials, use mineral spirits.

•Do not use mineral spirits on latex materials, or the mixture will turn into a jelly-like substance which is difficult to remove.

•No matter which cleaning solution you use, make sure to dispose of it properly when finished cleaning your sprayer.

•Thorough cleaning and lubrication of the sprayer is the most important step you can take to ensure proper operation after storage.

WARNING

Special cleaning instructions for use with flammable solvents:

•ALWAYS FLUSH SPRAY GUN AT LEAST ONE HOSE LENGTH AWAY FROM SPRAY PUMP.

•If collecting flushed solvents in one gallon metal container, place it into an empty five gallon container, then flush.

•Area must be free from vapors.

•Follow all cleanup instructions.

•DO NOT USE GASOLINE TO CLEAN YOUR SPRAYER.

Call 1-800-880-0993 if you have any problems or questions regarding the cleaning of your sprayer.

Cleanup - Latex materials

Follow these steps if you used latex materials AND if you have a garden hose available. If you do not have a garden hose available, follow the Cleanup - Oil-Based Materials instructions.

1.Lock the gun and remove the spray tip assembly. Place the suction tube and return tube into an empty waste container.

Empty waste

container

2.Using a garden hose, rinse off the suction tube, return tube and inlet filter. Empty the waste container.

3.Remove the inlet filter from the suction tube and place into the waste container.

4.Verify that the seal is present inside the adapter (a) Thread the pump cleaning adapter

(b)onto a garden hose

(c).Connect hose and adapter to the fitting on the end of the suction tube (d).

(d)

(b)

(a)

(c)

Continued on next page.

13 English