Wagner SprayTech 9140S, 9146, 9150, 9170, 9190 Cleanup Oil-based materials

Page 15

Cleanup - Oil-based materials

1.Lock the gun and remove spray tip assembly. Submerge suction set into a bucket with appropriate cleaning solution.

2.Place a waste container next to the original material container. Aim the spray gun into the side of the original material container and hold the trigger.

Hold trigger

Waste

containerOriginal material

Bucket with cleaning solution

Containers should be touching

container

• Hold trigger

• Turn pump ON (l)

• Turn PRIME/SPRAY knob to SPRAY

3. While pulling the gun trigger, turn the pump ON (l), and turn the PRIME/ SPRAY knob to SPRAY to purge material from the hose back into the original container.

Keep holding trigger through next steps.

4.When cleaning solution flows from the spray gun, keep holding the trigger and aim the spray gun into the side of the

waste container (ground gun with a metal container if flushing with flammable solvent).

5. Trigger the gun until the fluid flowing out of the gun is clear. You may need to dispose and obtain new cleaning solution.

Spray material into original container

6.Turn the PRIME/SPRAY knob to PRIME and trigger gun to relieve pressure.

Spray cleaning solution

into waste container

Move on to Cleaning the Suction Set.

15	English

Image 15

Contents Models 9140S, 9146, 9150, 9170 Hazard Explosion Hazard DUE to Incompatible Materials Important Electrical Information Grounding InstructionsCord gauge Maximum cord length Controls and Functions SpecificationsComponents and Description ComponentsPump cleaning adapter can be clipped to the spray hose port Assembly Tools needed for assemblyDo not plug in the sprayer until setup is complete GX-05GX-07 Pressure Relief ProcedureLocking the Spray Gun Plugging in the SprayerPurging and Priming the Sprayer Purging and Priming the Spray Hose Spray hoseKeep hands clear from fluid stream Practice / Spraying Technique Spraying Troubleshooting Unclogging the Spray Tip GX-05 / GX-07 GX-08GX-05 / GX-07 Spraying Troubleshooting Cleaning the Inlet Filter Spray gun model GX-07Spray gun models GX-05 and GX-08 Cleanup Latex materials Important Cleaning NotesKeep holding trigger through next steps Leave pump running through steps 7Containers should Be touchingCleanup Oil-based materials Minutes Cleanup Cleaning the Spray Gun Components GX-05 GX-07 GX-08 Short-Term Storage up to 16 hoursShutdown StartupSeparating oil Long-Term StorageCleaning the Inlet Valve Fluid Section Seal Replacement Instructions Disassembly of the Fluid SectionAssembly of the Fluid Section Troubleshooting / Maintenance Daily MaintenanceExtended Maintenance Parts List Liste de pièces Lista de piezas Articulo Modèle du pistolet GX-08Modelo de pistola GX-08 Article N de pièce Description QuantitéArticle Pieza# Descripción Cantidad Suction setJuego de succión Dispositif d’aspirationDescription Quantity Article De pièce Quantité Español Articulo Pieza# Descripción CantidadArticulo Pieza# Descripción Cantidad De pièce Description Accessories Accessoires AccesoriosWagner Spray Tech Warranty Garantié Garantia