|
|
|
| Assembly | |
|
|
|
| ||
|
| WARNING | Do not plug in the sprayer until setup is complete. | ||
|
|
| |||
| Tools needed for assembly: | ||||
|
| • Two adjustable wrenches |
| • Extension cord (refer to Important Electical | |
|
|
|
|
| Information (page 3). |
• 3/16” Allen wrench
If you have one of the cart models (9146, 9150, 9170 or 9190), follow these assembly instructions. If you have the model 9140S sprayer, skip to item 4, below.
1.Twist the knobs on either side of the handle counterclockwise to unlock the handle. Pull the handle out fully, and turn knobs clockwise to lock into place.
2.Insert the ends of the hose bracket into the holes of the handle as shown.
3.Attach the pail bracket. Line up the holes in the bracket with the holes in the sprayer. Insert and tighten the screws using a 3/16” allen wrench.
4.Thread the high pressure hose to the spray hose port. Tighten with an adjustable wrench.
5.Thread the other end of the hose to the spray gun. Hold the gun with one adjustable wrench, and tighten the hose nut with the other.
The spray tip SHOULD NOT be attached until after the sprayer and spray hose have been purged and primed.
6.Remove cap from inlet valve (a). Thread the suction tube onto the inlet valve and tighten firmly by hand. Be sure that the threads are straight so that the fitting turns freely.
7.Press the return tube onto the return tube fitting. Squeeze clip over the return tube fitting to secure the return tube.
8.Verify that the seal is present inside the suction tube. Thread the inlet filter into the end of the suction tube.
(a)
English | 6 |
|
|