Purging and Priming the Spray Hose
1.Unlock the spray gun and turn the PRIME/SPRAY knob to
PRIME.
The spray tip SHOULD NOT |
|
| |
be attached to the spray |
|
| |
gun when purging the | SPRAY | PRIME | |
spray hose. | |||
|
|
2.PULL the trigger and aim the spray gun at the side wall of a waste container. If using
WARNING | Keep hands clear from fluid stream. |
Ground the gun by holding it against the edge of a metal container while flushing. | |
| Failure to do so may lead to a static electric discharge which may cause a fire. |
|
3.While pulling the trigger, switch the pump ON (l), AND turn the PRIME/SPRAY knob to SPRAY. Hold the trigger until all air, water, or solvent is purged from the spray hose and material is flowing freely.
WARNING
If the PRIME/SPRAY knob is still on SPRAY, there will be high pressure in the hose and spray gun until the PRIME/SPRAY knob is turned to PRIME.
SPRAY
PRIME
4.Release trigger. Turn the PRIME/SPRAY knob to PRIME. Turn the pump OFF (O). Trigger the gun into the waste container to be sure that no pressure is left in the hose.
5.Lock the spray gun off. Thread the spray tip guard assembly onto the gun. Tighten by hand.
SPRAY
PRIME
Begin |
| . . .to achieve |
| ||
tightening |
| the desired |
the tip at |
| spray angle |
this angle |
| when tight. |
9 | English |
|
|