Cleanup - Latex materials (continued)
5.Unclip the return tube from the suction tube and place it into the waste container. Turn the PRIME/SPRAY knob to
PRIME.
SPRAY | PRIME |
6.Turn water supply on. Turn pump ON (l). Water will go into the suction tube and out through the return tube. Let pump run for a few minutes to allow the return tube to be flushed.
Leave pump running through steps 7 and 8.
7.Place the original material container next to the waste container. Aim the spray gun into the side of the original material container and hold the trigger.
Hold trigger
Waste | Original | |
container | ||
material | ||
| ||
Containers should | container | |
| ||
be touching |
|
8.While pulling the trigger, turn the PRIME/SPRAY knob to SPRAY to purge material from the hose back into the original container.
SPRAY
RIMEP
Keep holding trigger through next steps.
9.When cleaning solution flows from the spray gun, keep holding the trigger and aim the spray gun into the side of the waste container.
10.Trigger the gun until the fluid flowing out of the gun is clear. You may need to empty the waste container and continue flushing.
11.Turn the PRIME/SPRAY knob to PRIME and trigger gun to relieve pressure.
Spray water into waste container
Spray material
into original container
Move on to Cleaning the Spray Gun Components
English | 14 |
|
|