Components and Description
Components
The shipping carton for your painting system contains the following:
•Suction tube and return tube
•Pump cleaning adapter
•Spray gun with filter
•Spray tip assembly (see chart on next page)
•25’ (9140S, 9146, 9150) or 50’ (9170, 9190), 1/4” diameter pressure hose
•Separating Oil
•Instruction manual
•Hose bracket (all cart units)
•Pail bracket (all cart units)
Controls and Functions
ON/OFF Switch. . . . . . . . . . . The ON/OFF switch turns the power to the sprayer on and off (O=OFF, l=ON). Suction tube . . . . . . . . . . . . . Fluid is drawn through the suction tube into the pump.
Fluid Section . . . . . . . . . . . . A piston in the fluid section moves up and down to create the suction that draws fluid through the suction tube.
Spray Gun. . . . . . . . . . . . . . . The spray gun controls the delivery of the fluid being pumped. The gun model you have depends on your sprayer model (refer to Spray Gun/Tip Chart, next page).
Spray Hose . . . . . . . . . . . . . . The spray hose connects the gun to the pump.
Return Tube . . . . . . . . . . . . . Fluid is sent back out through the return tube to the original container when PRIME/SPRAY knob is in PRIME position.
Pump Cleaning Adapter . . . The adapter allows you to attach a garden hose to the suction tube for easy cleanup (latex materials only).
PRIME/SPRAY Knob . . . . . . The PRIME/SPRAY knob directs fluid to the spray hose when set to SPRAY or the return tube when set to PRIME. The arrows on the PRIME/SPRAY knob shows the rotation directions for PRIME and
SPRAY.
The PRIME/SPRAY knob is also used to relieve pressure built up in the spray hose (see Pressure
Relief Procedure, page 7).
Pressure Control Dial . . . . . The pressure control dial regulates the amount of force the pump uses to push the fluid.
Oiler. . . . . . . . . . . . . . . . . . . . (9146, 9150, 9170, 9190 only) The oiler is designed to provide lubrication to the fluid section of the pump.
Pusher Stem . . . . . . . . . . . . . The pusher stem is designed to keep the inlet valve open and from sticking due to dried materials.
Specifications
Capacity |
|
9140S | Up to .25 gallon (0.95 liter) / minute |
9146, 9150 | Up to .29 gallon (1.10 liters) / minute |
9170 | Up to .33 gallon (1.25 liters) / minute |
9190 | Up to .42 gallon (1.60 liters) / minute |
Power source |
|
9140S | 1/2 Hp universal motor |
9146, 9150 | 5/8 Hp universal motor |
9170 | 3/4 Hp permanent magnet DC motor |
9190 | 7/8 Hp permanent magnet DC motor |
Power requirement | 15 amp minimum circuit on 115 VAC, |
| 60 Hz current |
Generator power |
|
requirement | 8000 Watt |
Safety features | Spray gun trigger lock and pressure |
| diffuser; |
| PRIME/SPRAY knob for safe pressure |
| release. |
Capability | Sprays a variety of paints, oil base |
| latex, primers, stains, preservatives |
| and other nonabrasive materials, |
| including pesticides and liquid |
| fertilizers. |
| This pump should not be used with |
| textured materials, block filler, or |
| asphalt sealer. |
English | 4 |
|
|