Wagner SprayTech 9170, 9146, 9150, 9190 Pump cleaning adapter can be clipped to the spray hose port

Page 5

Components and Description

This pump is available in two models: a stand model (9140S) and cart models (9146, 9150 shown below, 9170 and 9190). All information given for the stand model applies to the cart models except where indicated.

Important

Some of the graphics in this manual may not exactly match your sprayer and spray gun. All information and instructions given in this manual applies to all models except where noted.

9140S

GX-05

415

415

Yellow (fine)

25 feet

9146, 9150

GX-07

415

517

Yellow (fine)

25 feet

9170

GX-07

517

519

White (medium)

50 feet

9190

GX-08

517

521

White (medium)

50 feet

**The pump cleaning adapter can be clipped to the spray hose port

Hose bracket

Pressure control dial (rear of sprayer)

Oiler (9146, 9150, 9170 and 9190only)

Spray hose port (reverse side)

ON / OFF switch* (reverse side)

Pail bracket

Pusher stem

Return tube

Suction tube

Clip

Suction set filter

Pump cleaning

adapter**

Spray hose

PRIME/SPRAY knob

Return tube fitting

Spray gun (see chart above for models, GX-07 shown)

Spray

guard Spray tip (see chart above

for models)

5

English

 

 

Image 5
Contents Models 9140S, 9146, 9150, 9170 Hazard Explosion Hazard DUE to Incompatible Materials Cord gauge Maximum cord length Important Electrical InformationGrounding Instructions Components and Description SpecificationsComponents Controls and FunctionsPump cleaning adapter can be clipped to the spray hose port Do not plug in the sprayer until setup is complete AssemblyTools needed for assembly Locking the Spray Gun Pressure Relief ProcedurePlugging in the Sprayer GX-05GX-07Purging and Priming the Sprayer Keep hands clear from fluid stream Purging and Priming the Spray HoseSpray hose Practice / Spraying Technique GX-05 / GX-07 Spraying Troubleshooting Unclogging the Spray TipGX-05 / GX-07 GX-08 Spray gun models GX-05 and GX-08 Spraying Troubleshooting Cleaning the Inlet FilterSpray gun model GX-07 Cleanup Latex materials Important Cleaning NotesContainers should Leave pump running through steps 7Be touching Keep holding trigger through next stepsCleanup Oil-based materials Minutes Cleanup Cleaning the Spray Gun Components Shutdown Short-Term Storage up to 16 hoursStartup GX-05 GX-07 GX-08Separating oil Long-Term StorageCleaning the Inlet Valve Assembly of the Fluid Section Fluid Section Seal Replacement InstructionsDisassembly of the Fluid Section Extended Maintenance Troubleshooting / MaintenanceDaily Maintenance Parts List Liste de pièces Lista de piezas Modelo de pistola GX-08 Modèle du pistolet GX-08Article N de pièce Description Quantité ArticuloJuego de succión Suction setDispositif d’aspiration Article Pieza# Descripción CantidadArticulo Pieza# Descripción Cantidad Description Quantity Article De pièce QuantitéEspañol Articulo Pieza# Descripción Cantidad De pièce Description Accessories Accessoires AccesoriosWagner Spray Tech Warranty Garantié Garantia