Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| |||
| ACCESSORIES | ||
| CONNECTION OF LINCOLN |
|
|
| ELECTRIC WIRE FEEDERS |
|
|
| The Lincoln Electric | 3. | Connect the |
| ed for wire feed welding with the Classic I. |
| pin amphenol on the Wire Feed Module. |
|
| 4. | Attach the single lead from the |
| CONNECTION OF THE |
| to the work using the spring clip on the end of the |
|
| lead. This is only a control lead — it carries no | |
| CLASSIC I “ACROSS THE ARC” WITH |
| welding current. |
| WIRE FEED MODULE (SEE FIGURE C.1.) | 5. | Place the IDLER switch in the “HIGH” position. |
| 1. Shut the welder off. | 6. | Adjust wire feed speed and voltage at the |
2.Connect the electrode cable from the
NOTE: Welding cable must be sized for current and duty cycle of application.
NOTE: Figure C.1 shows the electrode connect- ed for positive polarity. To change polari- ty, shut the welder off and reverse the electrode and work cables at the Classic I output terminals. Reverse the
FIGURE C.1
CLASSIC I/LN-25 ACROSS THE ARC CONNECTION DIAGRAM
14PIN AMPHENOL
+ | |
CV- | WITH |
VOLTAGE CONTROL OPTION |
| ELECTRODE CABLE |
TO | WORK CLIP |
WORK | LEAD TO WORK |