Return to Master
Return to Master TOC
Return to Master TOC
10.Rotate the adjustment arm assembly counterclockwise to release the tension on the idle arm.
11.Swing the idle arm up and away from the wire drive assembly.
12.Use a screwdriver and remove the round head screw, lock washer, and flat washer securing the molded drive roll shaft assembly to the wire drive assem- bly.
13.Remove the molded drive roll shaft assembly and the rest of the outer guide assembly from the wire drive assembly.
14.Use a screwdriver and remove the pan head screws and lock washers secur- ing the motor/gearbox assembly to the wire drive assembly.
15.Grasp the motor/gearbox assembly and wiggle the motor/gearbox assembly gently back and forth until it separates from the wire drive assembly.
16.Use a 7/16 in. nutdriver to remove the hex head cap screws, lock washers, and flat washers securing the wire drive assembly to the wire drive compartment.
17.Remove the wire drive assembly from the wire drive compartment.
18.Reassemble the wire drive assembly in the reverse order.
Return to Section TOC
Return to Master TOC