Section TOC
Master TOC
TROUBLESHOOTING & REPAIR |
WIRE DRIVE ASSEMBLY REMOVAL AND REPLACEMENT (continued)
FIGURE F.12 — WIRE DRIVE ASSEMBLY REMOVAL FOR CODES 10563 & 10583 REFER TO P344-F.2
FOR EXPLODED VIEW OF WIRE DRIVE FOR CODES 10986 AND 10990 - SIMILAR PROCEDURE
2
17
18
19
1.Wire Drive Assembly
2.Motor/Gearbox Assembly
3.Flange Nut
4.Positive Lead
5.Hose Clamp
6.Flex Hose
7.Outer Guide Assembly
8.Thumb Screw
9.Adjustment Arm Assembly
10.Idle Arm
11.Round Head Screw
12.Lock Washer
13.Flat Washer
14.Molded Drive Roll Shaft Assembly
15.Pan Head Screw
16.Lock Washer
17.Hex Head Cap Screw
18.Lock Washer
19.Flat Washer
9
4
3
7
10
1 | 16 | 8 |
5 |
| |
15 |
| |
|
| |
6 | 13 | 12 |
|
|
11
14
Return
Return to Section TOC
Return
Return to Master TOC
PROCEDURE
1.Disconnect main input power to the machine.
2.Remove the wire gun and wire.
3.Lift the wire drive door to gain access to the wire drive assembly.
4.Lift the tool tray door to allow access to the tool tray.
5.Use a 5/16 in. nutdriver and remove the tool tray to gain access to the motor/gearbox assembly.
6.Disconnect the wire connectors J13 and J12 to the motor/gearbox assem- bly. See Wiring Diagram.
7.Use a 3/4 in. wrench and remove the flange nut and positive lead from the wire drive assembly. See Figure F.12.
8.Use pliers to remove the hose clamp and flex hose from the wire drive assembly.
9.Remove the outer guide assembly from the wire drive assembly by loosening the thumb screws until the outer guide can be removed.