Lincoln Electric CV-400-I manual To AN LN-25, CV/CV-I Power Source

WARNING

ELECTRIC

SHOCK

CAN KILL

CV/CV-I POWER SOURCE

N.C.

Turn off input power to the Welding Power Source using the disconnect switch at the fuse box Before connecting the wire feeder.

Only qualified persons should install, use or

service this machine.

14 PIN	OPTIONAL K857
	REMOTE CONTROL
AMPHENOL

CV POWER

F-6

CV-400-I

+-

	OPTIONAL K864 REMOTE
	CONTROL ADAPTER
OPTIONAL	LN-25
K484 JUMPER
	WIRE FEEDER
PLUG

SOURCE

DIAGRAMS

N.D.

TO WORK

ELECTRODE CABLE

N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION. N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF",

REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE.

N.C. USE OF THE K857 REMOTE CONTROL REQUIRES INSTALLATION OF A K864 REMOTE CONTROL ADAPTER TO THE 14 PIN AMPHENOL OF THE POWER SOURCE.

N.D. CONNECT THE K484 JUMPER PLUG DIRECTLY TO THE 14 PIN AMPHENOL OF THE POWER SOURCE IF NO REMOTE CONTROL IS USED.

IF USING A K857 REMOTE CONTROL,CONNECT THE K484 JUMPER PLUG TO THE 14 PIN AMPHENOL OF THE K864 REMOTE CONTROL ADAPTER.

THE POWER SOURCE WELDING TERMINALS ARE ALWAYS "HOT" WHEN THE K484 JUMPER

6-18-93

S20661

TO AN LN-25

F-6