Lincoln Electric SVM170-A service manual Figure A.2 Triple Voltage Machine Input Connections

	A-5	INSTALLATION	A-5
Return to Section TOC	Return to Master TOC	FIGURE A.2 — TRIPLE VOLTAGE MACHINE INPUT CONNECTIONS.
Return to Section TOC	Return to Master TOC

FIGURE A.3 — RECEPTACLE DIAGRAM. OUTPUT POLARITY CONNECTIONS

		CONNECT TO A SYSTEM	The welder, as shipped from the factory, is connected
		GROUNDING WIRE. SEE	for electrode positive (+) polarity. This is the normal
		THE UNITED STATES
			polarity for GMA welding.
		NATIONAL ELECTRICAL
		CODE AND/OR LOCAL
		CODES FOR OTHER	If negative (–) polarity is required, interchange the con-
TOC		DETAILS AND MEANS FOR
	TOC		nection of the two cables located in the wire drive com-
		PROPER GROUNDING.
		CONNECT TO HOT WIRES	partment near the front panel. The electrode cable,
Section	Master		which is attached to the work clamp, is to be connect-
		PHASE OF A TWO OR
		OF A THREE-WIRE, SINGLE	which is attached to the wire drive, is to be connected
		PHASE SYSTEM OR TO ONE	to the negative (–) labeled terminal. The work lead,
Return to	Return to	THREE PHASE SYSTEM.	ed to the positive (+) labeled terminal.

Return to Section TOC Return to Master TOC

POWER MIG 255C