Return to Section
Return to Section TOC
Return to Master
Return to Master TOC
PROCEDURE
1.Remove the case side panels using a 3/8 in. nutdriver.
2.Disconnect lead #208S and trans- former lead X1 from the heat sink on the left side of the machine using a 1/2 in. socket wrench. See Figure F.13.
a.Thin lead is always on the outboard side of the connection.
FIGURE F.13 — LEFT HEAT SINK
LEAD DISCONNECTION.
3.Disconnect lead #204 and heavy alu- minum choke lead from the middle heat sink with a 1/2 in. socket wrench and 1/2 in. open end wrench. See Figure F.14.
4.Remove the diode lead from the nega- tive capacitor band buss bar on the right side of the machine using a 1/2 in. socket and 3/8 in. open end wrench.
FIGURE F.14 — MIDDLE HEAT SINK
LEAD DISCONNECTION.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
| MIDDLE | HEAVY |
LEFT | HEAT SINK | LEAD LEAD |
HEAT SINK | LEAD X1 | #204S |
|
| |
| LEAD |
|
| #208S |
|