OPERATION | ||
|
|
|
Return to Master TOC
5.Loosen the socket head cap screw that holds the connector bar against the gun bushing.
Important: Do not attempt to completely remove the socket head cap screw.
6.Remove the outer wire guide, and push the gun bushing out of the wire drive. Because of the pre- cision fit, light tapping may be required to remove the gun bushing.
7.Disconnect the shielding gas hose from the gun bushing, if required.
8.Connect the shielding gas hose to the new gun bushing, if required.
9.Rotate the gun bushing until the thumb screw hole aligns with the thumb screw hole in the feed plate. Slide the gun receiver bushing into the wire drive and verify the thumb screw holes are aligned.
10.Tighten the socket head cap screw.
11.Insert the welding gun into the gun bushing and tighten the thumb screw.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE B.4
THUMB SCREW
TORNILLO DE PULGAR
VIS DE POUCE
GUN RECEIVER BUSHING
BUJE DEL RECEPTOR DEL ARMA
DOUILLE DE RCEPTEUR DE PISTOLET
OUTER WIRE GUIDE GUŒA DE ALAMBRE EXTERNA GUIDE DE CBLAGE EXTERNE
CONNECTOR BLOCK |
| |
BLOQUE DE CONECTADOR | SOCKET HEAD | |
BORNIER | ||
CAP SCREW | ||
|
TORNILLO DE CASQUILLO |
|
|
| |
DE LA CABEZA DE ZCALO | LOOSEN | TIGHTEN | ||
VIS PRINCIPALE DE | ||||
|
|
| ||
LA DOUILLE CAP | AFLOJE | APRIETAN | ||
SERRENT | ||||
POWER MIG 255C