Friedrich HEAT&COOLING MODEL INVERTER (REVERSE CYCLE) ROOM AIR CONDITIONER WALL MOUNTED TYPE

Page 5

PREPARATION

Turn on the Power

1

In the case of a direct line connection, turn on the cir-

cuit breaker.

 

 

 

 

Load Batteries (AAA/R03/LR03 2)

 

1

Press and slide the battery compartment lid on the re-

verse side to open it.

 

 

 

 

 

Slide in the direction of the arrow while pressing the mark.

2

Insert batteries.

 

 

 

 

Be sure to align the battery polarities (

) correctly.

3

Close the battery compartment lid.

Set the Current time

 

 

 

 

1

Press the CLOCK ADJUST button (Fig. 6 W).

Use the tip of a ball-point pen or other small object to press the button.

2

Use the TIMER SET (

/

 

 

) buttons (Fig. 6 P) to

 

 

adjust the clock to the current time.

 

 

 

button: Press to advance the time.

 

 

 

 

button: Press to reverse the time.

 

 

 

 

 

 

(Each time the buttons are pressed, the time will be advanced/reversed in

 

one-minute increments; hold the buttons depressed to change the time

 

quickly in ten-minute increments.)

 

 

 

 

3

Press the CLOCK ADJUST button (Fig. 6 W) again.

This completes the time setting and starts the clock.

To Use the Remote Control Unit

The Remote Control Unit must be pointed at signal receiver (Fig. 1 4) to operate correctly.

Operating Range: About 7 meters.

When a signal is properly received by the air conditioner, a beeping sound will be heard.

If no beep is heard, press the Remote Control Unit button again.

CAUTION!

Take care to prevent infants from accidentally swallowing batteries.

When not using the Remote Control Unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.

Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the Remote Con- trol Unit’s operating range becomes ap- preciably reduced, replace the batteries and press the RESET button with the tip of a ballpoint pen or other small object.

Remote Control Unit Holder

Insert

Slide up

Press in

Pull out

Screws

 

1 Mount the Holder. 2 Set the Remote Control

3 To remove the Remote

Unit.

Control Unit (when use at

 

hand).

En-4

06B029_9315255037-01_En

4

2006.2.6, 10:52 AM

Image 5
Contents Español Français English Operating ManualSafety Precautions ContentsSpecifications Fiche TechniqueInverter Features and FunctionsIndoor Unit Operating Control Panel Fig Manual Auto button Name of PartsPreparation Operation About Auto Changeover Operation About Mode OperationTo Stop Operation Press the START/STOP button R Timer Operation About the Sleep Timer Sleep Timer OperationDuring Heating operation During Cooling/Dry operationVertical Air Direction Adjustment Press the SET button S Adjusting the Direction of AIR CirculationRight-Left Adjustment Adjust the Right-Left louvers Types of Air flow Direction SettingCoil DRY Operation Swing OperationManual Auto Operation To select Swing Operation Press the Swing button TCleaning and Care Install the two Air filters and close the Intake Grille Install the Air cleaning filter set setReplacing dirty Air cleaning filters Replace them by two new Air cleaning filtersSee TroubleshootingSymptom Problem Operating Tips Event of Power InterruptionOperation and Performance Auto RestartCooling Mode Dry Mode Heating Mode Outdoor temperature Temperature and Humidity RangeIndoor temperature Tips for saving energy06B0299315255037-01En 2006.2.6, 1052 AM Précautions DE Sécurité SommaireInverseur Caractéristiques ET FonctionsManual Auto Nomenclature DES OrganesPréparatifs Fonctionnement Pour choisir le mode souhaitéAppuyez sur la touche Master Control K Réglage du thermostat Appuyez sur la touche SET TEMP. LArrêt du climatiseur Appuyez sur la touche START/STOP R Propos du mode de fonctionnementFonctionnement PAR Minuterie DE Programmation Appuyez sur la touche Timer Mode O pour’heure d’arrêt et de mise en marche souhaitées Rêt OFF et la mise en marche on par minuterieChangement des réglages du minuterie Fonctionnement TemporiséPropos de la minuterie à temporisateur Pendant le chauffagePositions de réglage de direction du flux d’air Réglage DE LA Direction DU Flux D’AIRRéglage Gauche-Droite Ajustez les Volets Gauche-Droite Fonctionnement DU Séchage DU Serpentin Fonctionnement OscillantFonctionnement MANUEL-AUTOMATIQUE Propos du fonctionnement oscillantNettoyez à l’eau Nettoyage ET EntretienRemettez la grille d’admission Nettoyez la poussière avec un aspirateur ou en lavantRemplacez-les par deux nouveaux filtres de nettoyage d’air Remplacement de filtres de nettoyage d’air salesRemarques sur les filtres de nettoyage d’air Entretien des filtres désodorisantsSymptôme Problème Voyez Guide DE DépannageFonctionnement et performance Conseils D’UTILISATIONRemise en marche automatique En cas de coupure de courantConseils pour une économie d’énergie Plage de température et d’humiditéTempérature intérieure Environ 64 F à 90 F Environ 5 F à 75 FPage Precauciones DE Seguridad ÍndiceInversor Funcionamiento DE Vaivén Características Y FuncionesAutomática Sleep Pantalla de vaivén Swing Denominación DE LOS ComponentesPreparativos Para seleccionar el modo de funcionamiento FuncionamientoPara ajustar el termostato Funcionamiento supersilencioso Super QuietNotas sobre el funcionamiento de los modos NotassobreelfuncionamientodecambioautomáticoAUTOCHANGEOVEREmpleo del temporizador programable Funcionamiento CON TemporizadorSi el aparato ya está funcionando pase al paso Nexión OFF y del de conexión onNotas sobre el temporizador de desconexión automática Sleep Para cambiar los ajustes del tiempoDurante el funcionamiento de calefacción Durante el funcionamiento de refrigeración/deshumectaciónTipos de ajustes de la dirección del flujo de aire Ajuste DE LA Dirección DE Circulación DEL AireFuncionamiento DE Deshumectación Coil DRY Funcionamiento DE VaivénFuncionamiento Manual Y Automático Para detener el funcionamiento de deshumectación Coil DRYLimpie con agua Limpieza Y MantenimientoColocación de la rejilla de entrada Saque el polvo con una aspiradora o la- vándoloSustitúyalos dos filtros de limpieza de aire nuevos Sustitución de los filtros de limpieza de aire suciosAcerca de los filtros de limpieza de aire Mantenimiento de los filtros desodorizantesLocalización DE Averías Síntoma Problema Vea la PáginaFuncionamiento y rendimiento Consejos Para EL FuncionamientoReinicio automático En el caso de una interrupción de la alimentaciónConsejos para el ahorro de energía Margen de temperatura y humedad

HEAT&COOLING MODEL INVERTER (REVERSE CYCLE) ROOM AIR CONDITIONER WALL MOUNTED TYPE specifications

The Friedrich HEAT&COOLING MODEL INVERTER (REVERSE CYCLE) ROOM AIR CONDITIONER is a top-tier wall-mounted solution that stands out in the competitive landscape of air conditioning units. Designed for both cooling and heating, this versatile inverter system is engineered to deliver optimal comfort year-round, regardless of the weather conditions outside.

One of the key features of this model is its advanced inverter technology, which allows for precise temperature control. Unlike traditional air conditioners that operate at a fixed speed, the inverter technology enables the compressor to adjust its speed based on the current demands of the room. This not only enhances energy efficiency but also provides a quieter operation, making it an ideal choice for bedrooms and living spaces.

The reverse cycle functionality means that the unit can efficiently switch between heating and cooling modes. In the cooling mode, it effectively removes heat and humidity from the indoor environment, while in the heating mode, it extracts heat from the outside air and transfers it indoors, even in colder temperatures. This dual capability makes the Friedrich model incredibly versatile for homeowners.

Another significant characteristic of this air conditioner is its energy efficiency ratings, typically classified under SEER (Seasonal Energy Efficiency Ratio) and HSPF (Heating Seasonal Performance Factor). This model boasts impressive figures that can lead to substantial savings on energy bills over time, making it an eco-friendly choice that aligns with modern sustainability goals.

The air conditioner also features smart technology integration, allowing users to control the unit remotely through a mobile app. This capability provides convenience and flexibility, enabling users to adjust settings from anywhere, ensuring their space is comfortable upon arrival.

The unit's design is sleek and modern, ensuring that it blends seamlessly with various interior décor styles while occupying minimal wall space. Additionally, the filter system is designed for easy access and maintenance, ensuring that clean air is circulated throughout the room while maintaining the unit’s performance.

Overall, the Friedrich HEAT&COOLING MODEL INVERTER room air conditioner merges innovative technology, energy efficiency, and user-friendly features, making it a premier choice for residential heating and cooling needs.