Craftsman 919.167461 owner manual Pressure reading

Page 20

	PROBLEM	CAUSE	CORRECTION
	Pressure reading	It is normal for "some"	If there is an excessive amount
	on the regulated	pressure drop to occur.	of pressure drop when the
	pressure gauge		accessory is used, adjust the
	pressure gauge		regulator as instructed in the
	(if equipped)		regulator as instructed in the
	(if equipped)		Operation section.
	drops when an		Operation section.
	drops when an		NOTE: Adjust the regulated
	accessory is		NOTE: Adjust the regulated
	accessory is		pressure under flow conditions
	used.		pressure under flow conditions
	used.		(while accessory is being
			(while accessory is being
			used).

	Air leak from	Possible defect in safety	Operate safety valve manually
	safety valve.	valve.	by pulling on ring. If valve still
			leaks, it should be replaced.

	Compressor is	Prolonged excessive use of	Decrease amount of air usage.
	not supplying	air.	Check the accessory air
	enough air to	Compressor is not large	Check the accessory air
	operate acces-	enough for air requirement.	requirement. If it is higher than
	sories.		the SCFM or pressure supplied
			by your air compressor, you
			need a larger compressor.
		Hole in hose.	Check and replace if required.
		Check valve restricted.	Remove and clean, or replace.
		Air leaks.	Tighten fittings.
		Restricted air intake filter	Clean or replace air intake fil-
			ter. Do not operate the air
			compressor with the filter
			removed. Refer to the "Air
			Filter" paragraph in the
			"Maintenance " section.

	Restricted air	Dirty air filter.	Clean or replace. See Air Filter
	intake.		paragraph in the Maintenance
			section.

	Regulator knob	Damaged regulator.	Have checked by a Trained
	has continuous		Service Technician.
	air leak.

	Regulator will	Damaged regulator.	Have checked by a Trained
	not shut off air		Service Technician.
	outlet.

D28071

20- ENG

Image 20

Contents AIR Compressor Table of Contents Specification Chart Safety Guidelines DefinitionsImportant Safety Instructions Model No 919-167461What Could Happen How To Prevent It Product when it is operatingSpray area. An additional length of hose Explosion May be requiredSoft tissue damage to exposed skin Before attempting maintenance, attachingTools or accessories Tank is designed to withstand specificErly it may cause electric shock Tive covers removed or damagedRepairs attempted by unqualified per Accordance with national and local electriOr attempt maintenance until unit has Result in serious burnsHot for several minutes after operation Do not reach around protective shroudsFire, Inhalation, Damage to Vehicle Surfaces Accessories AccessoriesGlossary Duty CycleAssembly InstallationUnpacking Location of the Air CompressorExtension Cords Voltage and Circuit ProtectionOn/Auto Off Switch OperationKnow Your Air Compressor Description of OperationHow to Stop Before StartingAir Compressor Pump Break-in instructions Risk of Unsafe Operation. SeriousHow to Start Before Each Start-UpMaintenance To Check Safety ValveCustomer Responsibilities To Drain TankAir Compressor Pump Intake and Exhaust Valves MotorService and Adjustments To Replace or Clean Check ValvePressure Relief Tube Nut Outlet Nut Check Valve Screwdriver Open position nothing is visibleStorage Troubleshooting Problem Cause CorrectionPressure reading Minal box area Garantía Total DE UN AÑO DEL Compresor DE Aire ContenidoGarantía Definiciones DE Normas DE Seguridad Modelo NºAdas Lesiones serias Daños en la propiedadaCómo prevenirlo Instrucciones Importantes DE SeguridadGuarde Estas Instrucciones Advertencia Riesgo de Explosión Qué puede occurrir Cómo prevenirloD28071 30- SP Advertencia Riesgo de Quemaduras Qué puede occurrir Advertencia Riesgo de Caída Qué puede occurrirAdvertencia Riesgo de Operación Lasegura Qué puede occurrir Glosario AccesoriosCiclo DE Servicio Presión mínima de corte Cuando elEnsamblado InstalaciónCómo Preparar LA Unidad DesempaqueRiesgo de Operación Cables de extensión eléctricaProtección del voltaje y del circuito Operación Conozca su compresor de aireDescripción de operaciones InterruptorCómo utilizar su unidad Antes de poner en marchaCómo detenerla Procedimiento para el asentamientoAntes de cada puesta en marcha Cómo poner en marchaMantenimiento Responsabilidades del clienteCómo verificar la válvula de seguri- dad Cómo drenar el tanqueFiltro de Aire Inspección y reempla- zo Tubo aliviador Servicio Y AjustesPara reemplazar o limpiar la válvu La de retención Almacenaje Guía DE Diagnóstico DE Problemas Problema Causa CorrecciónRiesgo Alguna porque se debilitaráOperación. Nota Ajuste la presión Compruebe la conexión de cablea D28071 46- SP Product replacement if your covered product cant be fixed Repair Protection AgreementsMY-HOME Sears Parts and Repair CenterCanada SU-HOGARSM