STORAGE
Before you store the air compressor, make sure you do the following:
1.Review the Maintenance section on the preceding pages and perform scheduled maintenance as necessary.
2.Set the On/Auto/Off lever to "Off" and unplug unit.
3.Turn the regulator counterclockwise and set the outlet pressure to zero.
4.Remove the air tool or accessory.
5.Pull ring on safety valve allowing air to bleed from the tank until tank pressure is approximately
20 psi. Release safety valve ring.
6.Drain water from air tank by opening drain valve on bottom of tank.
Risk of Bursting. Water will
condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.
7.After the water has been drained, close the drain or drain valve.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, and reinstalled.
8.Protect the electrical cord and air hose from damage (such as being stepped on or run over). Wind them loosely around the compressor handle. (If so equipped)
9.Store the air compressor in a clean and dry location.
A13640 | 18- ENG |