Studer Innotec HPC 2800-12, HPC 4400-24, HPC 6000-48, HPC 8000-48 manual Hp-Compact

Page 2

STUDER INNOTEC		HP-COMPACT
English description		5
1	General Information	5
1.1	Operating instructions	5
1.2	Quality and Warranty	5
1.3	Warranty Disclaimer	5
1.4	Liability Disclaimer	6
1.5	Warning	6
1.6	Special precautions	6
2	Introduction	7
2.1	Principle schematic	7
2.2	Description of the main functions	8
2.3	Battery connecting	9
3	Mounting and installing	10
3.1	Installation place	10
3.2	Fixing	10
3.3	Connections	10
3.4	Connection Plan	10
3.5	Cabling	11
3.6	Pre-installation settings	11
4	Control	14
4.1	Display and control parameters	14
4.2	Light Emitting Diodes (LED)	15
4.3	Push buttons	16
4.4	Turning Knobs	16
4.5	The Inverter	16
4.6	The battery charger	18
4.7	The Transfer system	20
4.8	The Multifunctional Contact	21
4.9	The Remote Control RCC-01	22
4.10	The Temperature sensor CT-35	22
4.11	Remote control for „Power Sharing“ RPS-01	23
5	Programming	23
5.1	Standard setting	23
5.2	Reset value (default settings)	24
5.3	Battery voltages and absorption time	24
5.4	Auxiliary contact	25
5.5	Disabling some of the HP-COMPACT functions	27
6	Installation Maintenance	27
7	Declaration of CE Compliance	27
8	Technical Data	28

HP-COMPACT V5.4

2/80

Image 2

Contents Sine wave Inverter, Battery charger, Transfersystem HP-COMPACT HPCHP-COMPACT General Information Quality and WarrantyWarranty Disclaimer Operating instructionsSpecial precautions Liability DisclaimerPrinciple schematic IntroductionDescription of the main functions Battery connecting Fixing Mounting and installingInstallation place ConnectionsPre-installation settings CablingConnection to battery 3.6.1.1 On the appliance side Connection to the 230Vac-consumer appliances AC Output Connection to Remote controlConnection to Temperature Sensor Temp Connection to the 230Vac Input AC InputControl Display and control parametersLight Emitting Diodes LED LEDInverter Push buttonsTurning Knobs Charge detection system „StandbyBattery Condition Overheating Over TempCycle of charge Battery chargerDefault values for battery voltage thresholds Equalization chargingCharging current Input current repartition Power sharingSet the Input Limit Transfer system Multifunctional Contact Fast UPS- Mode for the Transfer SwitchDelayed mode of the Transfer System Set the transfer voltage thresholdRemote Control RCC-01 HP-COMPACTProgramming Remote control for „Power Sharing RPS-01Standard setting Set the voltage and timing threshold Reset value default settingsBattery voltages and absorption time Principle Auxiliary contactTable of voltage and timing threshold Programming of the Auxiliary ContactPower cut of the second priority loads Manual operating of Auxiliary ContactDisabling some of the HP-COMPACT functions Installation MaintenanceDiagram of the different modes Declaration of CE ComplianceTechnical Data