Studer Innotec HPC 2800-12, HPC 4400-24, HPC 6000-48, HPC 8000-48 manual Cabling

Page 9

STUDER INNOTEC

HP-COMPACT

A

Battery +/-

Connection terminal (M8) for battery cable (HPC 4400-24/6000-

 

 

48/8000-48 with fuse)

B

Reserved

-

CRemote contr. Connection terminal for Remote Control RCC-01

DTransfer delay Slide switch for Transfer Delay

E

Equalize

Slide switch for equalization of the Battery

F

Temp.

Connection terminal for Temperature sensor CT-35 and/or

 

 

Remote Power Sharing RPS-01

G

Aux. Contact

Connection terminal for Auxiliary Contact

H

AC Input

Connection terminal for AC-input

J

ID Plate

Identification plate with Technical data and Serial number

K

AC Output

Connection terminal for AC-output

L

Reserved

-

M

Hole

Pass through hole for RCC-01, CT-35 and RPS-01

N

Protection

Thermal circuit breaker 30A (50A for HPC 8000-48) for the

 

 

Transfer system

3.5Cabling

Connecting the HP-COMPACT is a very important step of the installation. You must take care that all connection work is carried out in a clean and correct way and that under no circumstance a cable is connected to a wrong terminal.

Connecting of the HP-COMPACT must be carried out in the following order. In case

of dismantling this order must be reversed.

3.6Pre-installation settings

Before you start with the cabling of the HP-COMPACT you must set the type of battery. In case sealed-gel batteries are used then you must set the small slide- switch „Equalize“ which is on the front with the connection terminals, in OFF position. In case of „normal“ lead-acid – batteries, these can handle a higher equalizing

HP-COMPACT V5.4

11/80

Page 8 Page 10
Image 9
Page 8 Page 10
Contents HP-COMPACT HPC Sine wave Inverter, Battery charger, TransfersystemHP-COMPACT Warranty Disclaimer Quality and WarrantyGeneral Information Operating instructionsLiability Disclaimer Special precautionsIntroduction Principle schematicDescription of the main functions Battery connecting Installation place Mounting and installingFixing ConnectionsCabling Pre-installation settingsConnection to battery 3.6.1.1 On the appliance side Connection to Temperature Sensor Temp Connection to Remote controlConnection to the 230Vac-consumer appliances AC Output Connection to the 230Vac Input AC InputDisplay and control parameters ControlLED Light Emitting Diodes LEDTurning Knobs Push buttonsInverter Charge detection system „StandbyOverheating Over Temp Battery ConditionDefault values for battery voltage thresholds Battery chargerCycle of charge Equalization chargingInput current repartition Power sharing Set the Input LimitCharging current Transfer system Delayed mode of the Transfer System Fast UPS- Mode for the Transfer SwitchMultifunctional Contact Set the transfer voltage thresholdHP-COMPACT Remote Control RCC-01Remote control for „Power Sharing RPS-01 Standard settingProgramming Reset value default settings Battery voltages and absorption timeSet the voltage and timing threshold Table of voltage and timing threshold Auxiliary contactPrinciple Programming of the Auxiliary ContactManual operating of Auxiliary Contact Power cut of the second priority loadsDiagram of the different modes Installation MaintenanceDisabling some of the HP-COMPACT functions Declaration of CE ComplianceTechnical Data
Top Page Image Contents