Studer Innotec HPC 2800-12, HPC 4400-24, HPC 6000-48, HPC 8000-48 manual Remote Control RCC-01

Page 20

STUDER INNOTEC

HP-COMPACT

−Over temperature (LED 10 lit)

−Overload (LED 11 lit)

−Over or less voltage of batteries (LED 12 lit or blinking)

−HP-COMPACT is turned off manually or with a fault (LED 13 lit)

In case this function is not wished, it must be modified by programming according to procedure in chap. 5.4.

4.9The Remote Control RCC-01

As an option, a Remote Control can be connected to the HP- COMPACT. All operating controls and displays except from level adjustment are available on the Remote Control. The Remote Control is supplied with a 20m long cable. It can as long as 40m. The Remote Control is suitable for surface mounting on the wall or on to a switch board. It is fixed with 4 screws. The HP- COMPACT can also be programmed with the Remote Control. The Programming is described in the section „Programming“.

The output power and the charging currents are displayed on the Remote Control.

In the Remote Control there is an additional Alarm Contact and a built-in Control Input. These two functions are available through Tip-jack RJ11/4 for use. This Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent from the Auxiliary Contact of the HP-

COMPACT. This contact is active in case of an alarm of the

HP-COMPACT.

The Control Input is connected in parallel to the ON/OFF- push button. The HP-COMPACT can be switched on or off through this input with an impulse button or an impulse contact.

Caution: No external voltage should be connected to this Input Control.

Order Number for Remote Control: RCC-01

Dimensions: H x B x T / 111.5 x 136.5 x 25mm

4.10 The Temperature sensor CT-35

Operating voltage of lead-acid batteries change depends on the temperature. To correct the operating voltages according to the

HP-COMPACT V5.4

22/80

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Sine wave Inverter, Battery charger, Transfersystem HP-COMPACT HPCHP-COMPACT Quality and Warranty Warranty DisclaimerGeneral Information Operating instructionsSpecial precautions Liability DisclaimerPrinciple schematic IntroductionDescription of the main functions Battery connecting Mounting and installing Installation placeFixing ConnectionsPre-installation settings CablingConnection to battery 3.6.1.1 On the appliance side Connection to Remote control Connection to Temperature Sensor TempConnection to the 230Vac-consumer appliances AC Output Connection to the 230Vac Input AC InputControl Display and control parametersLight Emitting Diodes LED LEDPush buttons Turning KnobsInverter Charge detection system „StandbyBattery Condition Overheating Over TempBattery charger Default values for battery voltage thresholdsCycle of charge Equalization chargingCharging current Input current repartition Power sharingSet the Input Limit Transfer system Fast UPS- Mode for the Transfer Switch Delayed mode of the Transfer SystemMultifunctional Contact Set the transfer voltage thresholdRemote Control RCC-01 HP-COMPACTProgramming Remote control for „Power Sharing RPS-01Standard setting Set the voltage and timing threshold Reset value default settingsBattery voltages and absorption time Auxiliary contact Table of voltage and timing thresholdPrinciple Programming of the Auxiliary ContactPower cut of the second priority loads Manual operating of Auxiliary ContactInstallation Maintenance Diagram of the different modesDisabling some of the HP-COMPACT functions Declaration of CE ComplianceTechnical Data
Top Page Image Contents